Gage Bilt GB7720A 매뉴얼 - 페이지 4

{카테고리_이름} Gage Bilt GB7720A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB7720A 10 페이지. Installation tool

DESCRIPTION

WARNING:

THE BALANCE OF THIS TOOL IS DESIGNED FOR HORIZONTAL USE AND IS NOT SUITED FOR

ANY OTHER APPLICATIONS. GAGE BILT WILL BE PLEASED TO ADVISE FOR YOUR SPECIFIC

APPLICATION.

The GB7720A is a hydraulic installation designed to install 5/8" Bobtail® lockbolts. It weighs 15 lbs (6.8 kg)

and has a 1.900" (48.26 mm) rivet setting stroke and a rated pull load of 21,000 lbs. (93.41 kN) at 5,000 psi

(344.7 bar) PULL pressure.

The GB7720A installation tool is designed to operate at pressures up to 10,000 psi on hydraulic pressure de-

veloped by the Powerunit. Normal operating pressure is set at 5,000 psi (344.7 bar) PULL pressure and 4,000

(275.8 bar) psi RETURN pressure, enabling the tool to pull 5/8" Bobtail® lockbolts. The powerunit pressures

may be set using 942280 pressure setting gauge. The tool comes equipped with 24" hoses and electric cord

kit complete with quick disconnects.

BT20-7720-58 NOSE ASSEMBLY MUST BE ORDERED SEPARATELY.

OPERATION

WARNING:

ENSURE AIR HOSE IS SECURELY CONNECTED TO AVOID POSSIBLE HOSE WHIPPING.

WARNING:

OPERATOR

WARNING:

IT IS REQUIRED THAT EYE PROTECTION AND HEARING PROTECTION BE WORN DURING

OPERATION.

WARNING:

DO NOT PULL RIVET IN THE AIR. PERSONAL INJURY FROM FASTENER EJECTING MAY OCCUR.

CAUTION:

DO NOT USE BEYOND THE DESIGN INTENT.

When the tool is connected to a powerunit, operation is controlled by an air actuator in the handle. When the

air actuator is depressed, a directional valve in the powerunit directs oil to the front side of the piston

forcing it and the nose assembly puller rearward. This action causes the jaws to clamp onto the fastener pin-

tail and pull the sheets together. The anvil is forced forward, swaging the collar into locking grooves of the

fastener.

When the air actuator is released the directional valve reverses oil flow to the back of the piston and pushes

the nose assembly off of the swaged fastener.

S/N: 1004 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

MUST

READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.

Rev. 6/14