Gage Bilt GBP7500A 매뉴얼 - 페이지 3

{카테고리_이름} Gage Bilt GBP7500A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GBP7500A 8 페이지. Hydraulic installation c

페이지 인쇄

PLEASE READ THIS MANUAL BEFORE SERVICING OR USING THIS

TOOL. COMPLETE WITH WARNINGS AND CAUTIONS TO PREVENT

SEVERE PERSONAL INJURY OR DAMAGE THE TOOL.

GAGE BILT TOOLS ARE APPROVED TO INSTALL HUCK®, AVDEL®, CHERRY®, POP®

AND OTHER FASTENERS WHEN USED BY PERSONS WITH SPECIFIC TRAINING OF BLIND

WARNING

Do not pull fastener unless it is placed in

an assembly, pin will eject forcibly when

pintail breaks off. Severe personal injury

may result.

WARNING

When operating installation equipment

always wear approved eye protection. Do

not look in front of nose assembly or rear

of tool when installing fastener.

WARNING

Installation of fasteners may exceed

acceptable noise levels. Use approved

hearing protection.

WARNING

Do not remove and add hoses without

using flats on 750128 tube assembly.

Severe personal injury could result.

CAUTION

Keep Nose Assemblies clean and free of

chips and debris.

RIVET AND LOCKBOLT INSTALLATION EQUIPMENT.

NOTE:

CAUTION:

Always disconnect tool from powerunit

before performing any maintenance to

any tool or nose assembly. Insure that all

connections are proper and there are no

visible leaks from tool or hoses before

Insure that nose assembly and tip are

properly matched for the fastener being

Be sure there is adequate clearance for

tool and operator's hands before

proceeding. Keep fingers clear of any

moving parts. Keep fingers clear from

fasteners and installed materials. Severe

personal injury may result.

Hydraulic power units that deliver high

pressure for the "PULL" and "RETURN"

and are not equipped with relief valves

are specifically not recommended and

WARNING

connecting to power.

CAUTION

installed.

WARNING

may be dangerous.