Agria Hydrasplitter TPL 매뉴얼 - 페이지 6
{카테고리_이름} Agria Hydrasplitter TPL에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agria Hydrasplitter TPL 17 페이지.
페이지 인쇄Removing Trapped Air from the Hydraulic System (Bleeding)
After connecting the splitter for the first time and after work has been
performed on the hydraulic rams or valves, the Hydrasplitter will
have to have any trapped air removed before putting it into service.
This is known as "bleeding" the system.
To bleed the system perform the following steps:
1) Keeping the control level in the neutral position leave the
engine running for a few minutes (ensure that the oil reservoir
has been filled first);
2) Speed the engine up to between 1200 rpm and 1400 rpm;
3) Alternatively move the control lever fully from one position
to the other, repeating this a few times;
Check the hydraulic oil level after this procedure, topping up if necessary.
- 6 -