Gage Bilt GB585NT 사용자 설명서 - 페이지 3

{카테고리_이름} Gage Bilt GB585NT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB585NT 8 페이지. Installation tool

WARNING

Be sure there is adequate

clearance for tool and

operator's hands before

proceeding as severe personal

injury may result.

WARNING

Do not pull on pin without

collar, as it will eject

forcibly when pintail breaks

off and severe personal

injury may result.

CAUTION

Hydraulic power units

that deliver high pressure

for the "PULL" and "RETURN"

and are not equipped with

relief valves are specifically

not recommended and may be dangerous.

OPERATION

When the tool is connected to a powerunit, operation is controlled by the handle and foot peddle

on the GB902 powerunit. When the handle is moved to the 'A' position and the foot peddle is

depressed the powerunit directs fluid to the front side of the piston forcing it and the nose

assembly collet rearward. This action causes the jaws to clamp onto the fastener pintail and pull

the sheets together. The anvil is forced forward, swaging the collar into locking grooves of the

fastener. Further force breaks the pintail off, approximately flush with the collar.

When the handle is moved to the 'B' position and the foot peddle is depressed fluid will "dump"

back to the powerunit tank. This reverses fluid flow to the back of the piston and pushes the nose

assembly off of the swaged fastener. The pintail ejector hydraulically pushes the spent pintail out

of the nose assembly. When the piston is all the way forward it exposes another flat providing a

smaller passage for fluid to be "dumped" back to tank.