Gage Bilt GB704 원본 사용 설명서 - 페이지 7

{카테고리_이름} Gage Bilt GB704에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB704 20 페이지. Installation tool
Gage Bilt GB704에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지), 매뉴얼 (14 페이지)

페이지 인쇄

When the actuator lever assembly is depressed, the pressurized air inside of the tool is released allowing spring pressure to move the

valve spool assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a downward

direction. The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom of the tool.

Simultaneously, the piston rod assembly connected to the air piston assembly is also moving down, forcing hydraulic oil up and into the

front side of the head cylinder assembly, causing the piston to move to the rear of the head cylinder assembly. The internal components

of the attached nose assembly are also moving with the piston to start the fastener installation. When the fastener installation is completed,

the actuator lever assembly is released. Air pressure is then built up inside of the handle causing the valve spool assembly to return to its

original position and reversing the sequence directing air pressure to the rear of the head cylinder assembly, causing the piston to

move to the forward position.

Air exhaust

Piston Rod Assembly

moves down

Air Piston

moves down

GB704 S/N: 3213 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

PRINCIPLE OF OPERATION

PULL Cycle

Air exhaust

Pressurized Oil

Unpressurized Oil

Image may not reflect actual tool.

Piston Rod Assembly

moves up

Air Piston

moves up

Pressurized Air

Unpressurized Air

RETURN Cycle

Air exhaust

6/11 Rev. 5/22