Gage Bilt GB715 원본 사용 설명서 - 페이지 7

{카테고리_이름} Gage Bilt GB715에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB715 20 페이지.
Gage Bilt GB715에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지)

When the actuator lever assembly is depressed, the pressurized air inside of the tool is released allowing spring pressure to move

the valve spool assembly causing the air to be redirected. The air is directed to the top of the air piston assembly, moving it in a

downward direction. The air below the air piston assembly is then directed through the valve sleeve and exhausted out of the bottom

of the tool. Simultaneously, the piston rod assembly, connected to the air piston assembly, is also moving down, forcing hydraulic

oil up and into the front side of the head cylinder assembly, causing the piston to move to the rear of the head cylinder assembly.

The internal components of the attached nose assembly are also moving with the piston to start the fastener installation. When the

fastener installation is completed, the actuator lever assembly is released. Air pressure is then built up inside of the handle

assembly causing the valve spool assembly to return to its original position and reversing the sequence directing air pressure to the

rear of the head cylinder assembly, causing the piston to move to the forward position.

PULL Cycle

Air exhaust

Piston Rod Assembly

moves down

Air Piston

moves down

GB752 S/N: 3210 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

PRINCIPLE OF OPERATION

Piston Rod Assembly

moves up

Air Piston

moves up

Air exhaust

Pressurized Oil

Pressurized Air

Unpressurized Oil

Unpressurized Air

Images may not reflect actual tool

RETURN Cycle

Air exhaust

REV. 5/22