Gage Bilt GB208-625A 원본 사용 설명서 - 페이지 13

{카테고리_이름} Gage Bilt GB208-625A에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB208-625A 20 페이지.

•

Note: Gage Bilt does not recommend using a pneumatic lubricator or adding pneumatic oil to the air inlet on our tools or powerunits.

Stroke limiters are designed for the protection of the operator and equipment. Failure to operate tool with a stroke limiter as required

will result in damage to the nose assembly or tool and may result in personal injury. If you are unsure your nose assembly requires a

stroke limiter, contact Gage Bilt.

An extra relief valve (for use when a long-stroke tool is required), is included with each tool.

1. To install or remove stroke limiter (208112) on piston assembly (208111), see overhaul instructions (#1 thru #7) on pg.12.

2. To increase stroke to .750" (19 mm), remove stroke limiter (208112) and relief valve (208109) from piston assembly (208111).

Install the extra relief valve (208110) (flats to rear of the tool) in the piston assembly (208111). Note positions and locations

shown below.

Do NOT position relief valve

flats to front of tool.

GB208-625 / GB208-625A

STROKE LIMITER - INSTALLATION & REMOVAL

Stroke Limiter (208112)

Relief Valve (208110)

Front of tool.

Rear of tool.

Images may not

reflect actual tool.

Stroke Limiter (208112)

Piston Assembly (208111)

Position relief valve

flats to REAR of tool.

9/16 REV 6/22