Gage Bilt GB510ABOM 원본 사용 설명서 - 페이지 7

{카테고리_이름} Gage Bilt GB510ABOM에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB510ABOM 20 페이지. Installation tool

When the tool is connected to a powerunit, operation is controlled by a actuator to the hydraulic hoses. The GB510ABOM incorporates

an air actuator to send a signal; the GB510BOM an electric actuator. When the button is depressed, a directional valve in the powerunit

directs oil to the front side of the piston forcing it and the nose assembly collet rearward. This action causes the jaws to clamp on the

fastener pintail and pull the sheets together. The anvil is forced over the collar, swaging it into locking grooves of the fastener. Further

force breaks the pintail off, approximately flush with the collar.

When the piston nears the end of its stroke it exposes flats on the back of the unloading valve. These flats "dump" oil back to the

powerunit tank. When the button is released the directional valve reverses oil flow to the back of the piston and pushes the nose

assembly off of the swaged fastener. The spent pintail is released and drops out the back of the tool.

PULL Cycle

Piston Travel

PULL Pressure

GB510BOM/GB510ABOM INSTALLATION TOOL: S/N 1001 AND ABOVE

CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS

PRINCIPLE OF OPERATION

HYDRAULIC DIAGRAM

Relief

Valve

RETURN Pressure

Pressurized Oil

Unpressurized Oil

Images may not reflect actual tool

RETURN Cycle

Piston Travel

11/20 REV 121/22