Dyna-Glo Pro LPFA43H 사용 설명서 및 작동 지침 - 페이지 3
{카테고리_이름} Dyna-Glo Pro LPFA43H에 대한 사용 설명서 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo Pro LPFA43H 16 페이지. Propane construction heater
페이지 인쇄
PROPANE CONSTRUCTION HEATER
DYNA-GLO PROPANE FORCED AIR CONSTRUCTION HEATERS
The heater is designed and approved for use as a construction heater under ANSI Z83.7 CSA 2.14. It is hard
to anticipate every use which may be made of this heater.
AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.
Other standards govern the use of fuel gases and heat producing products in specific applications.
Your local authority can advise you about these.
IMPORTANT: READ THIS USER'S MANUAL CAREFULLY AND COMPLETELY BEFORE TRYING
TO OPERATE OR SERVICE THIS HEATER. IMPROPER USE OF THIS HEATER CAN CAUSE
SERIOUS INJURY OR DEATH FROM FIRE, EXPLOSION AND CARBON MONOXIDE POISONING.
This is a direct-fired forced air construction heater for either indoor construction or outdoor use. Its intended
use is primarily the temporary heating of buildings or structures under construction, alteration or repair. All the
products of combustion generated by the heater are forced through the heater and released into the area being
heated. This heater operates at approximately 98%+ combustion efficiency but still produces a small amount
of carbon monoxide. Humans can tolerate small amounts of carbon monoxide for short periods. Carbon
monoxide can build up in a heated space and failure to provide adequate ventilation could result in poisoning
or death.
For either indoor or outdoor use. Adequate ventilation shall be provided in accordance with OSHA 29 CFR
1926.154, Safety Requirements for Temporary and Portable Space Heating Devices and Equipment ANSI
A10.10, ANSI 223.1 / NFPA 54, Liquified Petroleum Gas Code, NFPA 58 or the National Gas and Propane
Installation Code, CAN B149.1 as appropriate.
•
Do not use this heater for heating human living quarters.
•
Use of direct-fired heaters in the construction environment can result in exposure to levels of CO, CO
NO
considered to be hazardous to health and potentially life threatening.
2
•
Do not use in unventilated areas
•
Know the signs of CO and CO
▫ Headaches, stinging eyes
▫ Dizziness, disorientation
▫ Difficulty breathing, feels of being suffocated
•
Proper ventilation air exchange (OSHA 29 CFR 1926.57) to support combustion and maintain acceptable
air quality shall be provided in accordance with OSHA 29 CFR Part 1926.154, ANSI A10.10 Safety
Requirements for Temporary and Portable Space Heating Devices and Equipment used in the Construction
Industry or the Natural Gas and Propane Installation Codes CSA B149.1
▫ Periodically monitor levels of CO, CO
start of the shift and after 4 hours.
▫ Provide ventilation air exchange, either natural or mechanical, as required to maintain acceptable indoor
air quality
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
WARNING
: NOT FOR USE WITH DUCT WORK.
WARNING
Air Quality Hazard
poisoning
2
and NO
2
2
CHECK WITH YOUR LOCAL FIRE SAFETY
existing at the construction site – at the minimum at the
, and
2
2