Gage Bilt GB808V 원본 사용 설명서 - 페이지 9
{카테고리_이름} Gage Bilt GB808V에 대한 원본 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB808V 20 페이지.
페이지 인쇄
WARNING:
Only qualified and trained operators shall install, adjust or use the assembly power tool for non-threaded
mechanical fasteners.
WARNING:
Operator
WARNING:
It is required that eye protection, hearing and foot protection be worn during operation.
WARNING:
The users or the user's employer must assess specific risks that could be present as a result after each use
based on their application.
● Ensure there is adequate clearance for tool and operator's hands before proceeding. Keep fingers clear of any
moving parts. Keep fingers clear from fasteners and installed materials. Severe personal injury may result.
● Verify that hydraulic hose fittings and couplings, air and electrical connections are secure.
● Verify
●
Ensure that there are no electrical cables, gas pipes, etc., which can cause a hazard if damaged by the tool
●
Do not use with any unapproved installation tool
WARNING:
Do not actuate fastener in the air. Personal injury from fastener ejecting may occur.
CAUTION:
Do not use beyond the design intent.
The GB808V series powerunit is designed to work in conjunction with Gage Bilt's split handle (SHA) or split riveter (SRA) fastener
installation tools.
GB808V POWERUNIT
HOW TO USE THE GB808V SERIES POWER UNIT
MUST
read and understand all warnings and cautions.
the air lines and/or hydraulic hoses are not a trip hazard.
Blind Fasteners
1.
Insert fastener into workpiece.
2.
Insert fastener into nose assembly.
Note: Always hold tool so pulling head is perpendicular to surface
of material in which fastener is being installed. Exert firm pressure
against fastener during installation.
3.
Press actuator to start cycle.
4.
Release actuator as soon as fastener breaks.
5.
Repeat steps 1 - 4.
Images may not reflect actual tool or fastener
.
9
.
REV. 2/23