Dyna-Glo RA18LPA 사용자 설명서 - 페이지 7

{카테고리_이름} Dyna-Glo RA18LPA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo RA18LPA 19 페이지. Propane construction heater
Dyna-Glo RA18LPA에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

PROPANE CONSTRUCTION HEATER

1. unit

2. Rear guard

3. Manual

4. hardware Kit

includes:

M8 Flat washers(4) locking Casters(2)

Estimated Assembly Time:

1. Remove heater from carton.

2. Remove all protective packaging applied to heater for shipment.

3. Retain carton and packing material until you confirm the unit operates and is found in good condition.

4. Check heater for any shipping damage. if heater shows any external or internal damage, promptly inform

dealer/distributor where you purchased heater.

5. Remove back cover.

6. locate the four (4) casters shipped with the unit. There are two (2) locking casters and two

non-locking casters. Also find the four (4) washers and wrench shipped with the casters.

7. Carefully lay the unit on its back.

8. place one washer on each of the threaded portions of the caster. (see Figure 1).

9. Thread the casters into the four threaded holes in the base of the unit by turning them

clockwise

. The locking casters should be placed at the front of the unit and the other two

at the back of the unit. (See Figure 1).

10. Tighten The casters using the wrench supplied with the casters.

11. install 20 lb propane cylinder. (see propane Supply section)

12. Install back cover by inserting the mounting tabs into the slots on the rear flange of the heater.

CAUTION: The casters must be installed onto the unit before it is used. Failure to install the

casters may result in a fire or explosion causing property damage, personal injury or loss of life.

FIGURE 1

CONTENTS

10 Minutes

UNPACKING THE HEATER

non locking Casters(2) 14 mm wrench(1)

Tools Required:

14 mm wrench (included)

waSheR

loCKing CaSTeRS

non-loCKing CaSTeRS

wRenCh inCluded wiTh CaSTeRS