Dyna-Glo RA18LPA 사용자 설명서 - 페이지 8
{카테고리_이름} Dyna-Glo RA18LPA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo RA18LPA 16 페이지. Propane construction heater
Dyna-Glo RA18LPA에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)
페이지 인쇄
PROPANE CONSTRUCTION HEATER
ALWAYS USE A PROPANE (LP) CYLINDER THAT HAS A CONNECTION DEVICE
IMPORTANT!
THAT IS COMPATIBLE WITH THE HOSE AND REGULATOR ASSEMBLY SUPPLIED.
CAUTION
HOSE BEFORE EACH USE. IF THE HOSE IS CUT OR FRAYED, REPLACE IT WITH THE
MANUFACTURER SUGGESTED ASSEMBLY.
1. Provide propane/LP supply system (see Propane Supply, page 7).
2. Insert the 20 lb propane cylinder into the rear of the heater and position it such that the outlet of the cylinder
valve is facing towards the front-left corner of the unit. See Figure 2.
&RQQHFW WKH ¿WWLQJ RI WKH KRVHUHJXODWRU DVVHPEO\ WR WKH F\OLQGHU RXWOHW 7XUQ WKH ¿WWLQJ FRXQWHUFORFNZLVH
into the threads of the cylinder valve. Some models have a hand wheel that can be slid off the nut
VR WKDW D ZUHQFK FDQ EH XVHG WR WLJKWHQ WKH ¿WWLQJ LI GHVLUHG
Position the regulator such that the side with the tower is facing
CAUTION
GRZQ DQG WKH ÀDW VLGH LV IDFLQJ XS 6HH )LJXUH
Ensure that the gas hose is not touching the unpainted heat shield
WARNING
at the front of the cylinder enclosure. See Figure 2.
4. Open propane/LP supply valve on propane/LP tank(s) slowly.
127( ,I QRW RSHQHG VORZO\ H[FHVV ÀRZ GHYLFH
LQ UHJXODWRU PD\ VWRS JDV ÀRZ ,I WKLV KDSSHQV
close propane/LP supply valve, wait one minute
(or until you hear a click) and open again slowly.
&KHFN DOO FRQQHFWLRQV IRU OHDNV $SSO\ D
solution of liquid dish soap and water to
gas joints. Bubbles forming show a leak
that must be corrected.
6. Close propane / LP supply valve
before attempting to
repair connection.
CONNECTING TO GAS SUPPLY
UNPACKING THE HEATER
THE PROPANE (LP) GAS PRESSURE REGULATOR AND HOSE
ASSEMBLY SUPPLIED WITH THE HEATER MUST BE USED
WITHOUT ALTERATION. BE SURE TO INSPECT THE REGULATOR
REGULATOR
PROPANE TANK
1-877-475-5660
FIGURE 2
HOSE TO HEATER
PROPANE/LP
SUPPLY VALVE
1-877-475-5660
8