Dyna-Glo RA18LPB 사용자 설명서 - 페이지 6

{카테고리_이름} Dyna-Glo RA18LPB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo RA18LPB 16 페이지. Propane construction heater
Dyna-Glo RA18LPB에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

PROPANE CONSTRUCTION HEATER

1. Unit

2. Rear Guard

3. Manual

4. Hardware Kit

Includes:

M8 Flat Washers(4) Locking Casters(2)

(VWLPDWHG $VVHPEO\ 7LPH

1. Remove heater from carton.

2. Remove all protective packaging applied to heater for shipment.

5HWDLQ FDUWRQ DQG SDFNLQJ PDWHULDO XQWLO \RX FRQ¿UP WKH XQLW RSHUDWHV DQG LV IRXQG LQ JRRG FRQGLWLRQ

4. Check heater for any shipping damage. If heater shows any external or internal damage, promptly inform

dealer/distributor where you purchased heater.

5HPRYH EDFN FRYHU

6. Locate the four (4) casters shipped with the unit. There are two (2) locking casters and two

QRQORFNLQJ FDVWHUV $OVR ¿QG WKH IRXU ZDVKHUV DQG ZUHQFK VKLSSHG ZLWK WKH FDVWHUV

7. Carefully lay the unit on its back.

8. Place one washer on each of the threaded portions of the caster. (see Figure 1).

9. Thread the casters into the four threaded holes in the base of the unit by turning them

clockwise

. The locking casters should be placed at the front of the unit and the other two

at the back of the unit. (See Figure 1).

10. Tighten The casters using the wrench supplied with the casters.

11. Install 20 lb propane cylinder. (see Propane Supply section)

,QVWDOO EDFN FRYHU E\ LQVHUWLQJ WKH PRXQWLQJ WDEV LQWR WKH VORWV RQ WKH UHDU ÀDQJH RI WKH KHDWHU

CAUTION: The casters must be installed onto the unit before it is used. Failure to install the

FDVWHUV PD\ UHVXOW LQ D ¿UH RU H[SORVLRQ FDXVLQJ SURSHUW\ GDPDJH SHUVRQDO LQMXU\ RU ORVV RI OLIH

FIGURE 1

CONTENTS

10 Minutes

UNPACKING THE HEATER

1-877-475-5660

Non Locking Casters(2) 14 mm Wrench(1)

Tools Required:

14 mm Wrench (Included)

WASHER

LOCKING CASTERS

NON-LOCKING CASTERS

WRENCH INCLUDED WITH CASTERS

1-877-475-5660