Active Silicon Harrier 18x HDMI 4K Camera 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} Active Silicon Harrier 18x HDMI 4K Camera에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Active Silicon Harrier 18x HDMI 4K Camera 9 페이지.
페이지 인쇄Mounting the Harrier 18x HDMI 4K Camera Evaluation Board onto
the camera
The evaluation board can be mounted on the back of the camera as shown in figure 3.
To mount the board please follow these instructions:
1. Get the mounting pillars. Two of the mounting pillars are slightly shorter than the other two.
At the back of the camera, you will see two threaded holes on the left-hand side.
Screw the shorter mounting pillars into these threaded holes.
2. At the back of the camera on the right-hand side, there are two screws that secure the
casing. Remove these screws with a small cross-headed screwdriver.
Store them safely in case you want to remove the evaluation board at a future date.
3. Screw the longer mounting pillars into the two threaded holes where the cross-headed
screws were.
4. If not already connected, carefully connect the 30-way KEL cable (J2) and the 24-way FFC
(J3) to the evaluation board.
5. Carefully connect the 24-way FFC cable to the FFC connector on the camera (J302).
6. Carefully connect the 30-way KEL cable to the KEL connector on the camera (J301).
It may be helpful to add a 360 degree twist to the KEL cable before connecting to the camera
as this helps the cable to coil up compactly when mounting the board on the camera.
7. Being careful not to damage the cables, align the board with the mounting pillars and insert
the screws to secure the board (see figure 3). Ensure that the cables fit neatly between the
board and the camera.
8. To use the HDMI interface carefully remove the protective insert from the HDMI socket (J4).
September 2021
HARRIER 18x AF-ZOOM HMDI 4K CAMERA
QUICK START GUIDE
Version 1.0.0 - September 2021
Page 5 of 9