Dyna-Glo RA18LPDGD 사용자 설명서 - 페이지 11

{카테고리_이름} Dyna-Glo RA18LPDGD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo RA18LPDGD 19 페이지. Propane construction heater
Dyna-Glo RA18LPDGD에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

PROPANE CONSTRUCTION HEATER

1. STop! Read and head warnings and cautions on the side of the heater.

2. Check that the gas supply to the heater is on.

3. push in gas control knob slightly and turn clockwise

Note: knob cannot be turned from "piloT"

do not force.

4. Wait five (5) minutes to clear any gas. Then smell for gas, including near the floor. if you smell gas, STOP!

Follow the leak checking section in the manual. if you do not smell gas, go to next step.

5. Push in the gas control knob slightly and turn counterclockwise

and depress for 5 seconds. (B)

Note: The first time that the heater is operated after connecting the gas supply, the control knob should be

depressed for at least 30 seconds. This will allow air to bleed from the gas system.

6. Depress control knob while depressing the piezo ignitor button . This should cause the spark from the

piezo ignitor to light the pilot gas. Keep control knob depressed thirtry (30) seconds before releasing.

If the pilot does not light, depress the control knob and turn to the "OFF"

7. when pilot is lit, turn the knob counterclockwise

or high

. (C)

FIGURE 3

LIGHTING INSTRUCTIONS

position to "oFF"

(A)

to "oFF"

position. (a)

unless the knob is pushed in slightly.

to "PILOT"

to desired heat level, low

(B)

(C)

position

position. Repeat steps 5 and 6.

, MediuM