Dyna-Glo RA18LPDGP 사용자 설명서 - 페이지 10

{카테고리_이름} Dyna-Glo RA18LPDGP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo RA18LPDGP 16 페이지. Propane construction heater
Dyna-Glo RA18LPDGP에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

PROPANE CONSTRUCTION HEATER

1. STOP! Read and head warnings and cautions on the side of the heater.

2. Check that the gas supply to the heater is on.

3. Push in gas control knob slightly and turn clockwise

Note: knob cannot be turned from "PILOT"

Do not force.

:DLW ¿YH PLQXWHV WR FOHDU DQ\ JDV 7KHQ VPHOO IRU JDV LQFOXGLQJ QHDU WKH ÀRRU LI \RX VPHOO JDV 6723

Follow the leak checking section in the manual. if you do not smell gas, go to next step.

3XVK LQ WKH JDV FRQWURO NQRE VOLJKWO\ DQG WXUQ FRXQWHUFORFNZLVH

DQG GHSUHVV IRU VHFRQGV %

Note: 7KH ¿UVW WLPH WKDW WKH KHDWHU LV RSHUDWHG DIWHU FRQQHFWLQJ WKH JDV VXSSO\ WKH FRQWURO NQRE VKRXOG EH

depressed for at least 30 seconds. This will allow air to bleed from the gas system.

'HSUHVV FRQWURO NQRE ZKLOH GHSUHVVLQJ WKH SLH]R LJQLWRU EXWWRQ 7KLV VKRXOG FDXVH WKH VSDUN IURP WKH

SLH]R LJQLWRU WR OLJKW WKH SLORW JDV .HHS FRQWURO NQRE GHSUHVVHG WKLUWU\ VHFRQGV EHIRUH UHOHDVLQJ

,I WKH SLORW GRHV QRW OLJKW GHSUHVV WKH FRQWURO NQRE DQG WXUQ WR WKH ³2))´

7. When pilot is lit, turn the knob counterclockwise

or HIGH

. (C)

FIGURE 3

LIGHTING INSTRUCTIONS

position to "OFF"

(A)

to "OFF"

position. (A)

unless the knob is pushed in slightly.

WR ³3,/27´

to desired heat level, LOW

(B)

(C)

SRVLWLRQ

SRVLWLRQ 5HSHDW VWHSV DQG

, MEDIUM