Dyna-Glo RMC- 95C6B 소유자 매뉴얼 - 페이지 7
{카테고리_이름} Dyna-Glo RMC- 95C6B에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo RMC- 95C6B 18 페이지. Portable
kerosene-heater
Dyna-Glo RMC- 95C6B에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지)
페이지 인쇄
AUTOMATIC IGNITION SYSTEM
For safety and convenience, this heater features an automatic ignition system.
2 "C" cell batteries, included with the heater, provide the power for the igniter which lights the wick once it has
been raised to its maximum height.
To use the automatic ignition system:
Make sure the batteries have been installed.
Turn the wick adjuster knob clockwise until the wick has been raised to its maximum height. (Fig.12)
Push the ignition lever (Fig.13) to bring the glowing igniter into contact with the wick.
This will cause ignition to occur.
As soon as you see that the wick has been lit, release the ignition lever. This will automatically lower
the burn chamber back down over the wick.
Rotate the burner knob from side to side a few times to make sure that the burner is positioned
properly on the wick adjuster.
Then begin following the steps outlined in "Adjusting the wick" (page 7)
IGNITION VIA MATCH
If you encounter a problem with the ignition mechanism, or if you have dead
batteries, it is possible to light the heater with a match. (Fig.14)
The procedure is as follows:
Turn the wick adjuster knob clockwise until the wick has been
raised to its maximum height.
Lift the burn chamber by using the burner knob.
Touch a lighted match to the exposed top edge of the wick.
Once you see that the wick has been lit, lower the burn chamber back down over the wick.
Rotate the burner knob from side to side a few times to make sure that the burner is positioned
properly on the wick adjuster.
Then begin following the steps outined in "Adjusting the wick" (page 7)
CAUTION : Make sure that you do not leave the match, or any portion of it (match head, etc.) in the burner
area. Debris left from the match can cause an uneven alignment of the burner and may result in
smoke, incomplete combustion, odor, or fire.
WICK
FlLAMENT
IGNITER
1~2mm
F
g i
1 .
2
6
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
F
g i
1 .
3
Fig.14
Match