Dawn Dawn PS510 운영 매뉴얼 - 페이지 2

{카테고리_이름} Dawn Dawn PS510에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dawn Dawn PS510 4 페이지.

Congratulations! You are now the proud owner of the most revolutionary

concept in speaker systems ever produced, the Dawn PS510. In order to

take advantage of all of the features and unique capabilities of this system,

please follow the guidelines set forth in this simple operation manual.

POWER REQUIREMENTS

Maximum mono power input should not exceed 250 watts @ 4 ohms. Maximum power input with stereo

power amp should not exceed 125 watts per channel @ 8 ohms. Of course, power amps with higher output

capabilities may be used, but some care is needed to ensure that no damage occurs to the speakers if overdriven.

CONNECTING POWER AMP TO SUBWOOFER

MONO

If a mono power amp is used, connect one cable from the speaker output jack, on the power amp, to left/mono

input on MI 510 subwoofer. This left/ mono input connects both the left and right sides of the system together

and presents a 4 ohm load to the amplifier.

STEREO CONNECTIONS

If you desire to use two (2) power amps, connect the power amp for the Left channel into the L Power In Jack.

Connect the power amp for the right channel into the R Power In jack.

Note: Connecting two power amps from different input signal sources such as main & monitor may result in

loss of low frequency response if both signal sources do not contain the same low frequency material. However,

a stereo program source, such as a CD/tape player, will work well.

SATELLITE CONNECTION

Connect a speaker cable from the left satellite output jack on the subwoofer to the speaker that is located on the

left side of the performing area. Likewise, connect a speaker cable from the right satellite output jack on the

subwoofer to the speaker located on the right side of the performing area. Do not operate the subwoofer

without connecting the Satellite speakers.

SPEAKER PLACEMENT

SUBWOOFER

The subwoofer can be located just about anywhere within the playing environment. For maximum volume and

bass response, point the mouth of the subwoofer toward any wall, or into a corner of the room. There should be

about 6-8 inches clearance between the speaker and the wall. For less bass, or when using outside, point the

mouth of the subwoofer into the playing area.