Dyna-Glo WORKHORSE FA43 Series 사용 설명서 및 작동 지침 - 페이지 7

{카테고리_이름} Dyna-Glo WORKHORSE FA43 Series에 대한 사용 설명서 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dyna-Glo WORKHORSE FA43 Series 16 페이지. Propane construction heater

페이지 인쇄

Dyna-Glo WORKHORSE FA43 Series 사용 설명서 및 작동 지침

PROPANE CONSTRUCTION HEATER

INFORMATION ON SIZE * CAPACITY OF PROPANE GAS CYLINDERS:

The chart below shows the number and size of propane tanks needed to run this heater.

*Less gas is vaporized at lower temperatures.

You may need two or more 100 pound (45 kg) tanks or one larger tank in colder weather.

(See the parts list for your model of heater to get the specified regulator assembly.)

The propane (LP) gas tank must also be equipped with the following:

• A collar to protect the Propane gas valve.

• A shutoff valve terminating a Propane gas cylinder valve outlet as specified in the

American National Standards for Compressed Gas Cylinder Valve Outlets and Inlet

Connections.

• A safety relief valve having direct communications with the vapor space of the tank.

• An arrangement of vapor withdrawal.

The propane (LP) gas pressure regulator and hose assembly supplied with

this heater must be used without alteration.

The hose assembly shall be visually inspected prior to each use of the heater. If it is evident

that there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the

heater being put into operation. The replacement hose assembly shall be that specified

by the manufacturer.

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

Temperature

(°F-°C) at tank

Above

32°F (0°C)

20°F (-7°C)

10°F (-12°C)

-10°F (-23°C)

-20°F (-29°C)

Number of Tanks

37,000-43,000 BTU/h

1 - 20lb (9kg)

2 - 20lb (9kg)

1 - 100lb (45kg)