Hi-Copy DMX-8631 U 사용자 설명서 - 페이지 3

{카테고리_이름} Hi-Copy DMX-8631 U에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Copy DMX-8631 U 19 페이지. Fully stand-alone cd duplicator device

Welcome to the DMX-8631E/F/U User's Guide

Thank you for your purchasing of DMX-8631E/F/U CD

duplicator controller. DMX-8631E/F/U features very easy operation

with three LEDs on front panel to inform you the operation result.

DMX-8631E/F/U uses IDE interface, one CD-ROM and one

CD-R/W drive are needed for proper operation.

1. Features :

DMX-8631E/F/U supports 48x speed (or up) writer.

With a combination of 52x CD-ROM and a 40x CD-RW writer,

DMX-8631E/F/U can back up a full 650MB data CD in about

3 minutes 20 seconds. Copying an audio CD or Video CD takes

longer, because their CD formats are different.

DMX-8631E is a fully stand-alone CD duplicator device.

DMX-8631F supports additional 1394 connection to PC.

DMX-8631U supports additional USB connection to PC.

IDE bus interface. Firmware upgradeable by a CD disc.

Auto format detection.

2. Before you start :

Before you start, please make sure your source CD is clean and

does not have any scratch on its surface. If a 40x CD-RW drive

is attached, you must select blank 40x CD-R media for the copy.

Use blank 16x, 24x or 32x CD-R media may turn on media

detecting function of CD-RW drive, it will automatically slow

down the writing speed according to the media detected.

Configure CD-R (CD-RW) as master device, and CD-ROM

as slave device. Set jumpers on them to correct positions.

DMX-8631E/F/U Installation Guide