Frigidaire 79071190100 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} Frigidaire 79071190100에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigidaire 79071190100 10 페이지. 30" gas range with electric ignition or standing pilot

페이지 인쇄

12. Make Sure Range is Level.

Leveltherange byplacinga levelhorizontallyon anoven rack.

Check diagonallyfrom frontto back, then level the range by

eitheradjustingtheleveling legsor byplacingshimsunderthe

corners of the range as needed.

13. After installation is complete, make sure all

controls are left in the OFF position.

Model and Serial

Number

Location

The serial plate is located under the lift-up cooktop.

When ordering parts for or making inquiresabout you r range,

always be sure to include the model and serial numbers and

a lot number or letter from the serial plate on your range.

Your serial plate also tells you the rating of the burners, the

type of fuel and the pressure the range was adjusted for when

it left the factory.

Before

You Call for Service

Check to make sure the house fuses or circuit breakers for

your rangeare not blown or open. Refer tothe Avoid Service

Checklist and operating instructions in your Owner's Guide. it

may save you time and expense. The list includes common

occurrences that are not the result of detective workmanship

or materials in this appliance.

Refer to the warranty in your Owner's Guide for our

toll-free service number and address. Please call or write

if you have inquiries about your range product and/or

need to order parts.

Care, Cleaning

and Maintenance

Refer to the Owner's Guide for operating and cleaning

instructions.

Ifremoving the range is necessary for cleaning ormaintenance,

shut off gas supply. Disconnect the gas and electrical supply.

If the gas or electrical supply is inaccessible, lift the unit

slightly at the front and pull out away from the wall. Pull only

as far as necessary to disconnect the gas and electrical

supply. Finish removing the unit for servicing and cleaning.

Reinstall in reverse order making sure to level the range and

check gas connections for leaks. See Anti-Tip Instructions for

proper anchoring instructions.

Gas Conversion

This range was adjusted for Natural or LP/Propane gas, as

specified on the serial plate.

Your regulator is in one of the two locations shown.

Do not remove the Pressure Regulator.

Pressure Regulatorlocation

Fro_ A_C_SS

tn negu_ton

Remc_e _ck Pan_l,

St_gl_n_v_

_er

Dra_,

for InSl_).

Eq_pped _th

la. Convert the Pressure Regulator

Self-Cleaning

Electric Ignition Models

Unscrew the cap from the pressure regulator. Be sure

springstays in place.

b. Turn the captothe desiredsetting(see illustration below).

Replacethecapoftheregulator.Theletters corresponding

with the type of gas being used should be visible on the

exposed end of the cap.

4 CAF_,

HOLLOWEND

TOWARDS

"_l

SOUD END

TOWARDS

REGULATOR

FOR NATURAL GAS

FOR L.R GAS

lb.Convert

the Pressure

Regulator

Non Self-Cleaning

Electric

Ignition

Models

Usinga screwdriver or coin,turnthecap counterclockwise

to release fromthe pressure regulator.Be sure the O-ring

gasket stays in place.

b. Turn thecap over and place intothe slots.Turn clockwise

to lock in position.The letterscorresponding withthetype

of gas being used shouldbe visible on the exposed end

of the cap.

HOLLOW END

SOLID END

TOWARDS _11

d'CAP_I

TOWARDS

REGULATOR

FOR NATURAL

GAS

_-J'

FOR LP. GAS

_I_O-RING

GASKET

(DO NOT REMOVE)

SPRING