Great Circle GUO054 사용 설명서 - 페이지 10

{카테고리_이름} Great Circle GUO054에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Circle GUO054 17 페이지. Wood chipper

1. GASOLINE IS HIGHLY FLAMMABLE AND MUST BE HANDLED WITH CARE. NEVER FILL THE TANK

WHEN THE ENGINE IS STILL HOT FROM RECENT OPERATION.

2. DO NOT ALLOW OPEN FLAME, SMOKING OR MATCHES IN THE AREA. AVOID OVER-FILLING AND

WIPE UP ANY SPILLS.

TO AVOID SERIOUS PERSONAL INJURY FROM ROTATING CUTTING BLADES, KEEP HANDS OUT OF

INLET WHILE MACHINE IS RUNNING.

WARNING: DO NOT USE GASOLINE CONTAINING METHANOL, GASOHOL CONTAINING MORE

THAN 10% ETHANOL, GASOLINE ADDITIVES OR WHITE GAS BECAUSE ENGINE/FUEL SYSTEM DAMAGE

COULD RESULT.

ENGINE IS SHIPPED FROM FACTORY WITHOUT OIL. YOU MUST ADD ENGINE OIL BEFORE STARTING

ENGINE.

Adding Fuel

To add fuel:

1. Remove the fuel cap.

2. Fill the tank. Do not overfill. Leave room in the tank for fuel expansion. Refer to your engine manual for specific fuel

recommendations.

3. Install and hand tighten the fuel cap.

Starting the Engine

1. See engine manual for starting up instructions.

2. Ensure engine is running full throttle before beginning chipping operation. On some engines, the throttle may not be

adjustable.

Stopping the Engine

1. See engine manual for shut down procedure.

2. Stopping the engine is the only way to stop the rotor from turning. With engines equipped with an adjustable throttle,

move the throttle to the SLOW position and wait for engine to be running a slow RPM. Then switch to STOP

ENGINE as shown in the engine manual.

TRANSPORTING AND STORAGE

1. Always observe safe refueling and fuel handling practices when refueling the unit after transportation or storage.

2. Never store the unit (with fuel) in an enclosed poorly ventilated structure. Fuel vapors can travel to an ignition source

(such as a furnace, water heater, etc.) and cause an explosion. Fuel vapor is also toxic to humans and animals.

3. Always use the hopper handle and built-in wheels to move the chipper shredder. Never lift the unit using the fuel

tank for support. If the unit must be lifted , always use at least two people, and always grip the unit securely using

the front leg and hopper handle.

4. Always follow the engine manual instructions for storage preparations before storing the unit for both short and long

term periods.

5. Always follow the engine manual instructions for proper start-up procedures when returning the unit to service.

6. Never store the unit or fuel container inside where there is an open flame or pilot light, such as in a water heater.

Allow unit to cool before storing.

Storage

Perform engine maintenance and storage measures listed in the engine owner's manual. This includes draining the

fuel system, or adding stabilizer to the fuel. NOTE: Do not store a fueled unit in an enclosed structure. (SEE GASO-

LINE FIRES AND HANDLING FUEL SAFETY)

Before starting the unit after it has been stored:

1. Check all fluid levels. Check all maintenance items.

2. Perform all recommended checks and procedures found in the engine owner's manual.

3. Allow the engine to warm up for several minutes before use.