682DRUMS CMA-4 매뉴얼 - 페이지 2

{카테고리_이름} 682DRUMS CMA-4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 682DRUMS CMA-4 5 페이지. High quality drum microphones

Read this first

Risk of damage

Please make sure that the equipment the microphone will be connected to fulfil all

safety regulations in your country and is fitted with a ground lead.

Connecting your microphone

The microphone provides a balanced 3‐pin male XLR output connector.

You can connect the microphone either to a balanced or an unbalanced microphone input.

XLR sockets on mixers or other equipment are almost always balanced microphone inputs.

Please use a high quality XLR cable.

You can also connect the microphone to an unbalanced jack (mono) input. Use a cable with a

female XLR connector and a 1/4 inch TS jack plug. Don't use cables longer then 5

meters/16ft, because unbalanced connections may pick up interference from magnetic fields

like power lines, electric motors, dimmers, to avoid hum and other noise.

The DCB‐4 and DCT‐4 are low impedance microphones and don't need phantom power. The

CMA‐9 is a condenser microphone that does requires phantom power (48v DC).

The DCB‐4 and DCT‐4 will not be effected by running phantom power.

Don't plug or unplug your microphone from your equipment unless the channel volume is

turned down fully or muted.

Cleaninge

Use a soft cloth to clean the surface of the microphone body.