Hi-Fly Espresso HFE98-28 SERIES 사용 설명서 - 페이지 2

{카테고리_이름} Hi-Fly Espresso HFE98-28 SERIES에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Fly Espresso HFE98-28 SERIES 6 페이지. Fast and easy

페이지 인쇄

Safety

Read the instructions carefully before use and keep them for future

reference.

To install unit: Slide unit into the rail system keeping with one hand latch

lifted till electrical and water connector are engaged properly and the other

hand on the handle at the base. Of the unit. Release latch and pull unit

towards you. You should not be able to slide the unit out from rail system.

To remove the unit: keeping the latch lifted pull the unit towards you using

handle at the base.

Make sure that the system voltage corresponds to that indicated on the

rating plate of the appliance.

Do not use the appliance if the water connector is not attached properly

The appliance should be disconnected:

1. If any anomaly occurs while the water is flowing

2. Before each cleaning or maintenance operation

NOTE:

Installation shall be accomplished in accordance with the

Functional Test

Before operating, be sure the water and electrical connectors are

attached properly Turn the machine on by pressing the (ON/OFF)

button. Wait until both (READY) lights illuminate before operating.

NOTE: Note: Both (READY) lights must illuminate before selecting the

espresso or steam function in order to let the heating elements reach the

appropriate working temperature.

IMPORTANT: UNITS WTH MANUALLY REFILLABLE WATER TANK

time if the unit is new or every time the water tank is refilled you

must brew coffee as your first operation so water will entry the

maker plumming systemsystem.

Maintenance

DAILY:

The following steps have to be performed after every flight.

The steam spout must be changed.

A cycle for each coffee section has to be performed without a coffee pod

inserted to clean the coffee pod holders, filters and the drain system.

A steam cycle shall also be performed.

The espresso maker shall be cleaned so that no coffee or coffee grains are

left visually in the machine.

THREE MONTHS MAINTENANCE

1. Clean the filter cup and filter, if necessary readjust and replace at least

every 3 months.

NINE MONTHS MAINTENANCE

Return unit to authorized repair Station for preventive maintenance program.

Please refer to approved repair station's addresses on the last page of this

manual.

1. Handle

2. Electrical Switch : "STEAM" /Indicator Light: Yellow LED

3. Electrical Switch : "ON/OFF" /Indicator Light: Red LED5

4. Electrical Switch: "HOT WATER" /Indicator Light: Yellow LED

IMPORTANT:"HOT WATER FUNCTION" does not work in units with

the nespressopro system. P/N HFE96-2810/HFE96-28A10

5. Electrical Switch : "COFFEE CUP"/Indicator Light: Yellow LED

6. Indicator Light:

7. Indicator Light:

IMPORTANT: "NO WATER LIGHT" does not work in units that are connected

to manually refillable water tanks P/N's HFE96-28A/HFE96-28A10

8. Indicator Light:

The first

Control Panel

"READY (STEAM)" /Green LED

"NO WATER" / Red LED

"READY (HOT WATER / COFFEE)" / Green LED