Agriair 2200PG-230 운영 및 유지보수 매뉴얼 - 페이지 3

{카테고리_이름} Agriair 2200PG-230에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Agriair 2200PG-230 6 페이지.

The AgriAir 2200PG air purifier generates friendly oxidizer plasma which seeks and destroys odors and bio-

contaminants at their source, in indoor commercial cultivation facilities. Our energy efficient purifier produces and

distributes oxidizer plasma naturally generated from humidity and oxygen in the surrounding area. The 2200PG is

sized to sanitize environments 3,000-8,000 cubic feet of flowering, drying and packaging rooms, without the use of

chemicals or ozone. It's portable, easy to install, scalable and ready to plug-in and go.

Agriair 2200PG

Airflow: 300 – 1600 CFM Variable speed blower. Note: *Airflows based on blower manufacturer curves. Different HEPA

filters may cause the flow to vary

Power Requirements: 115 VAC/60 Hz/11.6 amps

PCO Generators: (2) 14" Photo-Catalytic Generators

Filtration: 24" x 24" x 12" HEPA Filter 99.99%, 0.3μ, 24" x 24" x 1.5"MERV 8 prefilter

Recessed Controls: High/OFF/Speed Control Switch, Variable Speed Controller, Filter Change Light, Generator On/Off

Switches, Running Hour Meters

Motor: 1 HP w/Thermal Overload

Housing: Aluminum and Steel with Epoxy Paint, 5" Casters, Rubber Grip Handles

Exhaust Collar: 12 " Diameter

Size/Weight with Filters: 34"L x 26"W x 31"H, 140 lbs

Receiving Instructions

Visually inspect the unit for damage. Ensure that the filters have not been dislodged during shipping. The unit must be

operated with filters in place.

Operation of the Agriair 2200PG

The AgriAir 2200 PG is used to purify the air in highly sensitive environments at risk of bio-contamination such as

cannabis drying, trimming and packaging areas. It provides HEPA filtration and PCO technology to distribute enough

oxidizer plasma to maintain a high level of air sanitation and odor control in and odor control in 6,000-20,000 cubic

feet of space. The oxidizer plasma provides bio-protection 24/7 without the use of chemicals. This unit is portable, easy

to install and scalable to any size operation.

Operating Instructions

1) Turn the blower on by selecting a setting on the fan power switch; ON (high), FAN, Speed Controller (low).

1a) Select the preferred airflow level, using the speed control knob.

3) To turn on generator(s), switch the generator switch(es) to the ON position.

4) The orange LED turns on when the HEPA filter needs to be changed.

1. Unplug the unit and remove the filter protection gate.

2. Remove the used filter and install new one.

3. Slide the gate in the track.

Generator Cell Replacement

The generator cell's output slowly degrades and should be replaced after 25,000 hours of running.

1) Unplug the machine.

2) Remove the filters: primary/secondary filter & HEPA filter.

3) Remove the first generator by unplugging, then remove the (4) screws holding it in place. (Once the first generator is

removed, you will have access to the second generator.)