6K Products 15G36 작동 및 부품 설명서 - 페이지 7

{카테고리_이름} 6K Products 15G36에 대한 작동 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 6K Products 15G36 14 페이지. Simple saw system
6K Products 15G36에 대해서도 마찬가지입니다: 작동 및 부품 설명서 (12 페이지)

페이지 인쇄

The Power Beyond Port can connect to another valve for conveyor and clamp, or must go to the filter and tank. The

return hose can be #8 or 1/2" diameter for the first four feet. If a longer hose is required it must be #12 or 3/4" up

to thirty feet. If the total return hose length is greater than thirty three feet #16 or 1" hose should be used. The filter

must be rated for 20 GPM plus any additional pump flowing into it. The saw motor should run between 4000 RPM

and 5500 RPM. At this speed the pressure at the return to filter connection should not exceed 80 psi when the saw

motor is running. We do not recommend using quick disconnects but if you choose to use quick disconnects in the

tank line, first consult the manufacture to determine the correct size to keep the back pressure low enough in cold

temperatures. Failure to properly size the hose and filter or properly connect the return hose to a filter and tank will

shorten the motor shaft seal life and will not be covered by warranty.

Chain Tension and Sharpening

Figure 5 shows the chain tensioning screw. A #2 or #3 Phillips screwdriver is required to turn the tension screw. With

the supplied saw bar, correct tension is when the cutters come off the rails roughly 1/8" with a tug of finger

pressure. Refer to the Oregon Mechanical Timber Harvesting Handbook for more tensioning information and

sharpening information.

Fig. 5