Hi-Force AHP1120R Series 사용 설명서 - 페이지 5

{카테고리_이름} Hi-Force AHP1120R Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Force AHP1120R Series 8 페이지. Air driven hydraulic pumps
Hi-Force AHP1120R Series에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지)

페이지 인쇄

INSTRUCTION MANUAL – AIR DRIVEN HYDRAULIC PUMPS:

Model Series: AHP1120, AHP1120R, AHP1121, AHP1121R, AHP1122, AHP1122R, AHP1141, AHP1142,

HAP21011, HAP21012, HAP21014, HAP21016, HAP21021, HAP21022, HAP21024, HAP21026, HAP21031,

HAP21032, HAP21034, HAP21036, HAP21041, HAP21042, HAP21044, HAP21046,



Reconnect the air-line quick coupler

after binding the thread with Teflon

tape.



If the air filter is excessively

contaminated or damaged, it must be

renewed.



Order a new filter from the

manufacturer, referring to the list of

spare parts at the end of this manual.

7.3.1 - Checking the hydraulic oil on the 2,5

Litre pump (AHP1120/AHP1120R)

Periodically check that the pump contains the

correct quantity of hydraulic oil by checking

the level on the sight glass (Fig 13). If the oil

level, with cylinder retracted, is below minimum

(E, Fig 13a), refill using the recommended types

of oil.

7.3.2 - Checking the hydraulic oil on the 5/10

Litre pump (AHP1121(R)/ 1122(R)/ 1141/ 1142)

Periodically check the oil level, which must be

between the two notches on the oil cap

dipstick (F in Fig 13b).

7.4 - Hydraulic oil change

Change the oil at intervals of 250 duty hours.

This operation must be performed when the

cylinder is fully retracted: USE ONLY HI-FORCE

HFO46 OIL for your AHP Pump.



If the pump is mounted vertically,

disassemble it and position it

horizontally.



Use a slotted tip screwdriver to remove

the filler plug (Fig 1).



Empty the pump of oil by turning it

upside down over a suitable container.



Allow all the oil to flow into the

container and then fill the pump with

the quantity and type of new oil

specified above.



Clean the filler opening with a clean

cloth and refit the plug, pressing it fully

down or, if necessary, to the partially

inserted breather position.

7.5 - Troubleshooting

The chart below describes the possible issues

that could occur during operation of the

pump, together with an indication of the

appropriate corrective action. If the prescribed

action fails to solve the problem, contact the

manufacturer

Hi‐Force Limited – Prospect Way – Daventry – Northants NN11 8PL – United Kingdom

Tel: +44(0) 1327 301000: Fax: +44(0) 1327 706555: Website: www.hi‐force.com