AGRICOW BRUSH 사용 및 유지 관리 매뉴얼 - 페이지 8

{카테고리_이름} AGRICOW BRUSH에 대한 사용 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AGRICOW BRUSH 17 페이지. Pendulum

Assembly instructions:

The installation of THE Pendulum BRUSH consists of mounting it to the wall/girder using specific fastening systems,

followed by connection to the electrical system, which must be carried out by qualified personnel.

Optimal positioning and stable fastening are particularly important for the correct operation of the Agricow

pendulum brush. It is thus important to ensure that the mounting surface is stable and not exposed to vibrations

or movement.

Agricow advises against outdoor installation. Should this be necessary, it is mandatory to shelter

the box containing the electronic board and the box containing the sensor from rain or excessive

sunlight.

CAUTION:

The brush MUST be installed with the dedicated magnetothermal differential switch.

The procedures for installing the Pendulum brush are shown below.

The roller can be inserted in either direction.

The Pendulum brush is supplied with the machine body completely assembled and ready for installation,

excluding the assembly of the:

• SUPPORT BRACKET, WHICH MUST BE FASTENED TO THE WALL SO THAT THE BRUSH SUPPORT

CAN BE HOOKED TO IT ( Fig. I,2,3,4)

• ELECTRICAL CABLE, TO BE FASTENED INSIDE THE CLIPS ALREADY POSITIONED ON THE ARM

SUPPORT (Fig. 5)

• provide to keep at least 45 cm or 17,72" free between the existing cable and the first clip

(fig.5).

INSTALLATION AND ASSEMBLY

PENDULUM BRUSH