6K Products 25G36 작동 및 부품 설명서 - 페이지 6

{카테고리_이름} 6K Products 25G36에 대한 작동 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 6K Products 25G36 17 페이지. Connect and cut hydraulic chain

The return hose can be #8 or 1/2" diameter for the first three feet, if a longer hose is required it must be #12 or 3/4"

up to thirty feet. If the total return hose length is greater than thirty three feet #16 or 1" hose should be used. The

filter must be rated for 26 GPM plus any additional pump flowing into it. The saw motor should run between 4000

RPM and 5500 RPM. At this speed the pressure at the return to filter connection should not exceed 80 psi when the

saw motor is running. We do not recommend using quick disconnects but if you choose to use quick disconnects in

the tank line, first consult the manufacture to determine the correct size to keep the back pressure low enough in

cold temperatures. Failure to properly size the hose and filter or properly connect the return hose to a filter and

tank will shorten the motor shaft seal life and will not be covered by warranty.

Chain Tension and Sharpening

Figure 6 shows the chain tensioning screw. A #2 or #3 Phillips screwdriver is required to turn the tension screw. With

the supplied saw bar, correct tension is when the cutters come off the rails roughly 1/8" with a tug of finger

pressure. Refer to the Oregon Mechanical Timber Harvesting Handbook for more tensioning information and

sharpening information.

Fig. 6