Hi-Force JCH13 사용 설명서 - 페이지 2
{카테고리_이름} Hi-Force JCH13에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Force JCH13 2 페이지. Compact jacks
페이지 인쇄
for example sideways, upside down etc.
REMOVABLE STEEL SADDLE
JCS10
RELEASE VALVE
HOLLOW PISTON TO ALLOW
TENSIONING DUTIES
OIL FILLER PLUG
There are two safety devices fitted as follows:
Pressure relief valve to prevent
overloading
Steel stop ring to limit maximum stroke
TO LIFT OR PUSH LOAD
Using the key on the end of the operating lever, turn
release valve screw clockwise to close. Do not use
excessive force.
Put operating lever into either socket on the pump
mechanism, rotate to a comfortable position and
operate pump. The piston will rise and lift load.
When the piston reaches full stroke the stop ring
prevents the piston from rising further.
TO LOWER LOAD
Using key on operating lever, turn release valve
screw anti-clockwise to open.
valve SLOWLY will control rate of lowering. DO NOT
overload jack during lowering. The JCS jacks are
fitted with a return spring, the piston will retract even
under no load. JCH jacks need to be pushed back
either by the load, or by hand. Do not stand on the
jack when working in restricted spaces or at heights.
Hi-Force Limited – Prospect Way – Daventry – Northants NN11 8PL – United Kingdom
Tel: +44(0) 1327 301000: Fax: +44(0) 1327 706555: Website: www.hi-force.com
INSTRUCTION MANUAL:
Model Series: JCS & JCH Compact Jacks
OPERATING LEVER
ALTERNATE OPERATING
LEVER POSITION
PUMP MECHANISM
SWIVELS THROUGH
306
O
JCH10
Opening release
CARE AND STORAGE
Whenever possible wipe piston clean before
lowering. When the jack is not in use, store with the
piston retracted in a clean dry environment.
SAFETY WARNINGS!
ALWAYS raise the piston to the load.
DO NOT drop loads onto the Jack.
ALWAYS support the base of the Jack
when in use.
NEVER go under load when only the Jack
supports it.
DO NOT attempt to lift a load greater than
the capacity of the Jack.
Provide solid and flat foundation for the
jack to operate from.
Make sure that there is sufficient spare
lifting capacity and stroke when selecting
Jack/s for any application.
Check the Jack load rating before use.
Avoid off-centre loading.
Before using any hydraulic equipment, read the
operating instructions carefully and check that
they are fully understood.
Service & Maintenance:
Only genuine Hi-Force spare parts should be used
in the repair or servicing of these units.
We recommend that any servicing or repair of this
equipment is only carried out by an authorised Hi-
Force repair centre.
See
www.hi-force.com
For full and comprehensive details on this piece of
equipment and all of the Hi-Force range of lifting
and jacking equipment please go to:
www.hi-force.com
for more information