Gaggenau CE291 Series 사용 설명서 - 페이지 6
{카테고리_이름} Gaggenau CE291 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau CE291 Series 16 페이지. Glass
Gaggenau CE291 Series에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)
Setting the hob
This section informs you how to set the hotplates. The
table shows heat settings and cooking times for various
meals.
Switching the cooktop on and off
The main switch is used to switch the cooktop on and
off.
Switching on
#
Touch the symbol
. An audible signal sounds. The
indicator light above the main switch and the
indicators light up. The cooktop is ready to use.
Switching off
#
Touch the symbol
until the indicator light above the
main switch and the indicators go out. All hotplates are
switched off. The residual heat indicator remains on
until the hotplates have cooled down sufficiently
Notes
‒
The cooktop switches off automatically if all
hotplates have been switched off for more than 20
seconds.
‒
The settings remain stored for 4 seconds after the
cooktop has been switched off. If you switch it on
again during this time, the cooktop will operate
using the previously stored settings.
Setting a hotplate
Set the required heat setting in the settings range.
Heat setting 1 = Lowest power
Heat setting 9 = Highest power
Every heat setting has an intermediate setting. This is
identified by a dot.
Setting the heat setting
The cooktop must be on.
u
1
Touch the
symbol to select the hotplate.
‹
lights up in the heat setting indicator,
under the heat setting indicator.
6
2
Set the required heat setting in the settings range.
The hotplate is switched on.
Changing the heat setting
Select the hotplate and set the required heat setting in
‹
the settings range.
Switching off the hotplate
Use the
settings range to 0. After about 10 seconds, the residual
heat indicator appears.
Note: The last selected hotplate remains activated. You
can set the hotplate without selecting it again.
¬
lights up
u
symbol to select the hotplate. Set the