Airwheel R8 사용자 설명서 - 페이지 7
{카테고리_이름} Airwheel R8에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwheel R8 14 페이지.
페이지 인쇄Operating steps for beginners (electricity-assisted mode)
1.
Fold the kickstand and turn on the power switch. Hold the handle and sit on the saddle.
2.
One foot steps on the pedal and look straight ahead. Turn the accelerator handle down with right hand
to accelerate.
3.
When riders need to slow down or stop R8, riders put their fingers on the brake handle, and press
the brake handle hard until the scooter slows down or stops.
4.
When the brake is started, the accelerator will automatically cut off power.
Avoid using this product in bad weather conditions (e.g., rain, snow, or ice).
Please confirm whether the brake can be used normally when riders want to use it.
Safety
Please read User Manual carefully and follow riding requirements during the R8 ride. Please do
not use it until riders have read User Manual carefully and learned the performance well. Do not lend it
to those who cannot manipulate e bikes.
Important Note:
No urgent acceleration, rapid deceleration and sharp turns. Do not excessively lean forward and
backward. Do not over speed. When the electric quantity displays less power in the App or power
switch lights flash, it is recommended that the rider stop riding. If riding, please keep a low constant
speed. If there is a risk of falling, please protect personal safety first, do not consider R8. R8 may
produce wear and tear which may influence on the performance in the process of riding and parking.
So before riders ride the R8, it is necessary to do the following inspections:
1.
Rider needs to check whether the R8 is installed firmly, and is damaged or not.
2.
Do not place the front wheel's quick release on the side with disc brake, in case of accident.
3.
To install pedals, 35~40N.m is the recommended torque. Please make sure the pedals have been
fastened before use. If not, the rear screw tooth will be damaged and the pedals will fall off from
the bike which is not included in the Warranty.
4.
Rider needs to check the brake function and tyres, and to check whether the handle and folding lock is
fastened. If not, please tighten the screws.
5.
The chain should be tightened meaning that the distance between chain prolapse and tension is 10~15mm.
6.
Brake should be reliable and flexible to reset and it should increase the braking distance in rainy, snowy
and downhill riding.
7.
Adjust the handlebar, saddle height, and it must not be higher than the safety points on the vertical pipe
and the saddle tube. After adjustment of the horizontal pipe, the vertical pipe, saddle and saddle tube,
they should be fastened, ≥ 18N.m is the recommended torque.
8.
Rider needs to find an open space to practice, at least 4m*20m area, indoor and outdoor.
9.
Rider needs to have a full understanding of the surrounding environment to avoid the interference from
the vehicle, pedestrians, pets, bicycles and other obstacles.
10.
Rider needs a skilled assistant in the side. The assistant is proficient in riding R8 and familiar with the
guidelines for the use of scooters in all matters needing attention and riding method.
You need lots of practice to grasp the skill before you ride R8 safely. If you are not skilled, or fail to
follow the user guide of this product, it may cause rider or others injury or property loss. Our company
only takes the responsibility for product defects or damage, and we are NOT responsible for physical
injury or property loss related with using products.
- 06 -