Gaggenau CI 282 601 설치 지침 매뉴얼 - 페이지 7

{카테고리_이름} Gaggenau CI 282 601에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau CI 282 601 12 페이지.

Prepare Installation Space

P r e p a r e I n s t a l l a t i o n S p a c e

C reate the cut-out in the countertop according to the

installation diagram. The angle of the cut surface to the

countertop must be 90°.

The lateral cut-out edges must be flat in order to ensure

that the retaining springs are positioned properly on the

appliance. With multi-layered countertops, secure strips

laterally in the cut-out if necessary.

After creating cut-out, remove shavings. Seal cut

surfaces in a heat- and water-resistant manner.

Observe minimum distance between device underside

and cabinet surfaces of

The worktop into which the cooktop is installed must be

heat-resistant up to 140° F (90 °C).

The worktop must be reinforced if it is less than

(20 mm) thick.

If the thickness of the worktop into which the cooktop is

installed does not comply with the specifications,

reinforce the worktop using a fire- and water-resistant

material until it reaches the minimum thickness.

Otherwise, sufficient stability cannot be assured.

The worktop into which the cooktop is installed should

▯

withstand loads of approx. 133 lbs (60 kg).

Confirm the cooktop is level only after it has been

▯

installed.

For flush installation in tiled countertops:

Note: If necessary, raise the support surfaces using heat

and water resistant strips.

" (10 mm).

Model: CI 282 601

inch

Prepare Installation Space

en-us