Hi-Force HPS50 사용 설명서 - 페이지 5

{카테고리_이름} Hi-Force HPS50에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Force HPS50 14 페이지. Single-acting, low height pad cylinders

페이지 인쇄



Avoid damaging hydraulic hoses. ALWAYS route hoses to ensure that they are free from sharp

bends and kinks. Using a sharply bent or kinked hose will result in severe back-pressure, which can

lead to hose failure.



NEVER use a coupler/s to lift, carry or position a cylinder.



Servicing of hydraulic equipment must only be undertaken by a qualified technician.



DO NOT let familiarity gained with any hydraulic equipment allow you to become complacent.

Complacency with any equipment can result in a lack of discipline toward working guidelines and

safety principles.



DO NOT remove any labels from the product. Replace any damaged or unreadable labels

immediately.

2.4 Hydraulic Cylinder Specific Safety Precautions



DO NOT work under or near a load supported only by hydraulic means. A cylinder, when used as a

lifting device, should not be used as a load-holding device. Once lifted, all loads should be supported

using rigid mechanical structures.



NEVER exceed the maximum rated capacity of any hydraulic equipment. Hi-Force manufactures

HPS hydraulic cylinders to operate at a maximum working pressure of 700 bar (10,000 psi).

Overloading hydraulic cylinders can result in component failure and possible serious personal injury.



DO NOT connect a hydraulic pump with a higher pressure capacity rating to any Hi-Force cylinder

of this model series.



ALWAYS make sure that all equipment connected to the cylinder is in good working condition.



DO NOT weld any items to the cylinder unit or modify it in any way from its delivered condition. Your

warranty may be invalidated, and it could lead to serious personal injury.



NEVER attempt to connect or disconnect a tool / hose / component while the syste is under pressure.



NEVER leave a pressurised system unattended. If you must leave the area, release the pressure

and ensure the hydraulic relief valve on the pump is fully open.



DO NOT

drop or place heavy objects on a hydraulic hose, as this may cause

internal damage, which could result in rupture of the pressurised hose. A

ruptured hose could cause significant damage to components and possible

severe injury to personal operating nearby.

Failure to observe and obey the following safety precautions could result

in property damage, serious personal injury or death;

Operating Instruction Manual:

OM-HPS-01

Serial Numbers:

From: AF0316