Active SmartHome Repeater 설치 및 운영 매뉴얼 - 페이지 13

{카테고리_이름} Active SmartHome Repeater에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Active SmartHome Repeater 15 페이지. Active smarthome system

This will clear the previously programmed data and reset the Repeater, returning it

to the Factory Default settings.

1. 1. 1. 1.

Under Normal Mode, switch DIP Switch 3, the Repeater will emit 1 long beep

and the yellow LED will light up.

2. 2. 2. 2.

Press and hold the Test Button for 5 seconds. The Repeater will emit 1 long

beep to indicate it has been formatted.

3. 3. 3. 3.

To exit Clear Mode, switch DIP Switch 3 to the ON position. The Repeater will

emit 1 long beep and the yellow LED will fade out.

04. MAINTENANCE

4.1. Supervision

After installation, the Repeater will automatically transmit Supervision signals to the

Active SmartHome Gateway at random within a range of 30 to 50 minutes.

Should the Gateway receive no signal from the Repeater for during the Supervision

time period, it will consider that the sensor is out of order, unless and until any

activity "wakes up" the sensor, and so restores it to the previous connection session.

The platform will report this event each time it occurs.

4.2. Tamper Protection

4.2.

Tamper Protection

R e p e a t e r

I ns t a l l a t i on a nd O pe ra t i o n G ui d e

P a g e | 1 3