Daxten Voyager 300 설치 매뉴얼 - 페이지 3
{카테고리_이름} Daxten Voyager 300에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daxten Voyager 300 8 페이지. Kvm extender up to 100 or 300m
Daxten Voyager 300에 대해서도 마찬가지입니다: 사용자 및 설치 설명서 (16 페이지), 브로셔 (2 페이지)
페이지 인쇄Voyager 300
Introduction
Thank you for purchasing the Voyager 300 UTP Extender. This product will allow you to place your
Monitor and PS/2 Keyboard and PS/2 Mouse up to 350 meters away from your computer.
Product Features
Allows a user to control a PC from up to 350 meters (1200 feet) away, using a single CAT5,
5e or CAT 6 cable.
No additional software is required for operation.
Adjustable Video Equalisation - Compensates for loss of image quality due to cable length in
several steps with or without extra gain.
Fully buffered signals to ensure consistent remote operation of your PC
Dual Access allows for an additional keyboard, monitor and PS/2 mouse to be connected
through the local unit.
Operation
The Voyager is simple to install, with no software is required. Just connect the units up as described in
quick setup system guide and you're ready to work. Switch the computer off before wiring up the units.
Hardware Installation
Before connecting your computer to the Voyager Local unit, please ensure that it is powered off.
Connect your console devices to the Voyager remote unit. Note: the Voyager Remote requires power.
If your computer does not have a PS/2 mouse or keyboard port, you can use a PS/2 to USB converter
(2141-01U). This will allow you to connect the Voyager to your computer. The keyboard and mouse
that you connect to the Voyager unit must be PS/2.
With the constant changes in computers keyboards and mice on the market, it is impossible to
guarantee universal compatibility for the Voyager's keyboard/mouse emulation. The Voyager
emulation is compatible with almost all standard PC (Intel/AMD based) BIOS systems.
The local unit is normally powered from the computer through the keyboard connector. Some
computers do not supply enough power through the keyboard connector; this necessitates the use of
a 5VDC mains adapter on the local unit. The Voyager 300 Local Unit is equipped with a DC jack for
the use of an optional power supply. This jack is normally not used, since most computers supply
enough power through the keyboard connector.
If you daisy chain the local with other equipment, please use a separate 5 volt supply (9014-00A) for
the local unit.
Rear Panel Layout Voyager 300 Remote Unit
Rear Panel Layout Voyager 300 Local Unit