Gaggenau VG 231 HK 사용 설명서 - 페이지 7
{카테고리_이름} Gaggenau VG 231 HK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau VG 231 HK 12 페이지. Gas wok
Gaggenau VG 231 HK에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)
페이지 인쇄
Operation
The markings on the control knob show the setting
between high and low heat. The flame setting is
infinitely variable between high and low heat.
Notes
‒
Only light a burner if all pan supports and burner
parts are properly assembled.
‒
Make sure the burners and ignition sparkers are
clean and dry.
‒
Fully press down the control knob and keep it
pressed, then turn it to the required position.
‒
After igniting, keep the control knob pressed for
around 2 to 4 seconds more. The thermal sensor
which controls the gas flow must be heated before
the knob can be released.
‒
If the flame should not ignite within 2 to 4 seconds,
turn the control knob further to the left to the low
heat position and then back to the high heat
position after ignition. It is often faster to ignite the
burner in the low heat position because the various
gases have a differing ignition response.
‒
Only use the recommended accessories. Do not
cover the stainless steel cooktop base (e.g. with
aluminium foil).
Switching on automatically
Your cooktop features ignition sparkers for automatic
ignition.
1
Place a suitable pot or pan on the burner.
2
Fully press down the corresponding control knob
and turn it anticlockwise to the ignition position
The burner lights automatically.
3
Keep the control knob pressed for a few seconds
after ignition. Then turn it left to the required
setting.
The flame size can be set continuously between high
and low by slowly turning the control knob.
Switching on manually
During a power cut you can ignite the burner manually.
1
Place a suitable pot or pan on the burner.
2
Press the control knob and turn it anticlockwise to
the ignition position
pressed.
3
Use a gas lighter or a match to ignite the burner.
Keep the control knob pressed for a few seconds
after ignition. Then turn it left to the required
setting.
Switching off
Turn the corresponding control knob clockwise to the
OFF position.
Thermoelectric flame monitoring
For your safety, the hob is fitted with thermoelectric
flame monitoring. This prevents the flow of gas if the
burner accidentally goes out while it is in use (e.g. due
to draughts).
If the burner accidentally goes out while it is in use, turn
the control knob to the 0 position and wait at least one
minute before you ignite the burner again.
§
. Keep the control knob
§
.
7