Daxten VOYAGER IP - 사용자 설명서 - 페이지 9
{카테고리_이름} Daxten VOYAGER IP -에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daxten VOYAGER IP - 15 페이지.
페이지 인쇄Adjusting the Video settings
To change the video settings, from the Toolbar click the Video icon. This will give
you the following options:
Refresh
Manual Video Adjust
Auto Video Adjust
Refresh – Refreshes the Video image (Press Ctrl + R ).
Manual Video Adjust – Used to fine tuning the video settings or for a non standard
Video signal.
To adjust the video manually:
1. Click Manual Video Adjust, a slider bar appears, and a Red frame appears
around the screen. This represents the screen area of the server at its
current resolution. Perform the adjustments‟ inside and relative to the red
frame.
2. Move the sliders to change the displayed image. Click in the area of the
sliders for fine tuning.
Brightness / Contrast
the displayed image.
Horizontal Offset
- defines the starting position of each line on the displayed image.
Vertical Offset
- defines the vertical starting position of the displayed image.
Phase
- defines the point at which each pixel is sampled.
Noise Level
- represents the Video "noise" when a static screen is displayed.
Automated adjust
– When checked, the video adjusts automatically whenever there is a change
in the screen resolution.
Auto Video Adjust
To Adjust the video automatically, open a Windows Explorer (or similar) in the background, click Auto
Video Adjust. The process will take a few seconds. If the process runs more than three times, then
there is an abnormal noise level. Check the video cable and ensure that there is no dynamic video
application running on the Target Server‟s desktop.
Perform as necessary for each Target server or screen resolution.
Power Cycle
The optional KB-Power and KB-Power IPMI offer remote power control via a remote session.
To shut down and restart the Target Server via KB-Power / KB-Power IPMI, from the toolbar click the
Power icon. A prompt appears, click Yes to continue.
Only an administrator can initiate a hard reset command.
The Power Management Console can be accessed when the Power Management Console is
activated.
Keyboard key sequences
Click the Keyboard icon. A list of defined keyboard sequences
appears, when clicked these will be transmitted to the Target
Server and will not affect the client computer.
For example, select Ctrl-Alt-Del to send this three key sequence to
the Target Server.
To add a keyboard sequence, Click Add/Remove, the Special Key
Manager box appears.
To add a predefined sequence:
Click Add Predefined, a list of sequences appears.
Select the desired sequence and click OK. The sequence appears in the Special Key Manager Box.
Click OK, the sequence appears in the Keyboard Key sequence list.
Voyager IP
- use the scales to adjust the brightness and contrast of
9
Figure 11 – Manual
Video Adjustments
Figure 12 – Special key Manager Box.
.
User Guide
controls.