Hi-Link HLK-LD2420 사용자 설명서 - 페이지 9

{카테고리_이름} Hi-Link HLK-LD2420에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Link HLK-LD2420 16 페이지.
Hi-Link HLK-LD2420에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)

페이지 인쇄

The explanation of the parameters involved in the upper computer tool interface is detailed in Table 4-

Parameter

Name

Used to set the minimum distance gate for radar detection.

Minimum

Distance

Used to set the maximum distance gate for radar detection.

Maximum

distance

The target state is switched from occupied to unoccupied with a

Target

disappearance

unoccupied and report unoccupied if it detects unoccupied for a

Delay time

occupied, which is more than 5 times the noise level. Please

Trigger

Threshold

The sensitivity for detecting human micro-movements and

maintaining the presence of a person is recommended to be

Maintain

threshold

4.2.3 for the scanning and data viewing of the bottom noise.

4.2.2. Bottom noise scanning

The Uplink Bottom Noise Scan page is shown in Figure 4-3. Scanning the bottom noise through

the Uplink is divided into three steps:

Step 1: Set the scan interval and scan duration.

Step 2: Set the path to save the data files.

Step 3: Click "Start Scan".

The noise data is stored as a folder in the set file path with a timestamp added to the folder name

suffix for differentiation. No one is kept in the scan area during the scan noise.

HLK-LD2420

Table 4-2 Explanation of the parameters of the upper computer tool interface

Explanation

The resolution of the distance gate is 70 cm.

delay of T: during this time, if an occupied state is detected, the

timing of this period is restarted. The radar will only switch to

full T time.

It is recommended to set the sensitivity from unoccupied to

refer to 4.2.2 and 4.2.3 for bottom noise scanning and data

viewing.

set at 2~5 times the noise level. Please refer to 4.2.2 and

第 7 页共 14 页

User Manuals

Parameter Range

0~15

(need not be less than the

minimum distance)

0~65535