Great Lighting GLM002-200 사용자 설명서 - 페이지 12

{카테고리_이름} Great Lighting GLM002-200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Great Lighting GLM002-200 15 페이지.

Gobo wheel speed control

FAST SPEED

5. Control signal connection

XLR-XLR control cable from the DMX output of the controller connected to each projector DMX input port,

and from the first fixture in the DMX output port connected to the second fixture in the DMX input port, and so

on, until the All lighting connection is completed, and then plug the supplied loop connected to the signal output

of the last fixture to complete the connection, as shown:

Note: Keep in mind that in the last fixture's output circuit connected to a plug, this circuit is connected to a 120

ohm resistor inserted between the CANON (XLR) plug 2 feet and 3 feet, this loopinterpolation can effectively

avoid the reflection signal generated by DMX512 signal in transfer input process.

The moving head light utilization the 3-pin XLR socket (head),if you are using the controller uses a 5-pin XLR

socket (head), you must use a 5-pin to 3-pin converter cable, as shown below:

3-pin and 5-pin control cable plug (male and female) connector.

Three pin（Canon）DMX512 connector

- 12 -