Gaggenau DI 230 사용 설명서 - 페이지 15
{카테고리_이름} Gaggenau DI 230에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau DI 230 19 페이지.
페이지 인쇄
Installation
The dishwasher must be connected by a qualified
technician to ensure correct operation. The
specifications for supply, drainage and connected load
must fulfil the required criteria as stated in the following
paragraphs or in the installation instructions.
Install the appliance in the following sequence:
– Check the delivery
– Install the appliance
– Connect the waste water
– Connect the fresh water
– Connect the power supply
Delivery
Your dishwasher was checked at the factory to ensure
that it was in perfect working order. This may have left
some small water stains in the dishwasher. These will
disappear after the first rinse cycle.
Installation
The required installation dimensions can be found in
the installation instructions. Using the height-adjustable
feet, adjust the appliance until it is level. Ensure that
the appliance is standing firmly.
Waste water connection
See the installation instructions for the required
connection steps. If required, attach a siphon with
drainage spigot. Using the enclosed parts, connect the
waste water hose to the drainage spigot of the siphon.
Ensure that the drainage hose is not kinked, crushed or
twisted (ensure that there is no sealing cover which
prevents the waster water from flowing away!).
Fresh water connection
Using the enclosed parts, connect the fresh water
connection to the tap according to the installation
instructions. Ensure that the fresh water connection is
not kinked, crushed or twisted.
When replacing the appliance, always connect a new
water supply hose to the water supply. The old supply
hose must not be re-used.
Water pressure:
Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10
bar).
If the water pressure is higher, install a pressure
reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend cold water connection only.
Electrical connection
This appliance should only be connected to a 230V /
240V AC source via a properly installed earthed
socket. See nameplate for size of required fuse.
The socket must be installed close to the dishwasher.
If you need to extend the mains connecting lead, do not
cut off the plug. Replace the whole cable, which can be
disconnected at the junction box on the rear of the
appliance.
If the domestic wiring includes a residual-
current-operated (FI) circuit-breaker, make sure that it
bears the
mark, as only this type conforms to the
latest regulations
Disconnecting the dishwasher
Here too, it is important that tasks are carried out in the
correct sequence: always unplug the appliance from
the mains electricity first of all.
Pull plug out of wall socket.
Turn off water supply.
Disconnect drain and water input hoses.
Remove screws in underside of work surface. Detach
base board, if fitted.
Pull out appliance and carefully withdraw hoses at
same time.
Transporting the dishwasher
Drain water from the dishwasher. Secure all loose
parts. The appliance should only be transported in an
upright position.
If the appliance is not kept upright during transport,
any water left inside may seep into the control
module and cause subsequent errors with
programme functions.
Transporting the dishwasher
Drain water from the dishwasher. Secure all loose
parts. The appliance should only be transported in an
upright position.
If the appliance is not kept upright during transport,
any water left inside may seep into the control
module and cause subsequent errors with
programme functions.
Drain the appliance according to the following steps:
Turn on the tap.
Close the door.
Select ECO programme.
Switch on the main switch.
Wait until approx. 4 minutes have elapsed.
Rotate programme selector to the Reset
position.
After another minute switch off the appliance.
Turn off the tap.
Protection from freezing temperatures
If the appliance is installed in a location where there is
a risk of freezing temperatures (e.g. in a holiday home),
all water must be completely drained out of the interior
(see "Transporting the dishwasher").
Turn OFF the tap, disconnect the supply hose and
allow to drain.
15