Gaggenau 200 Series 빠른 참조 매뉴얼
{카테고리_이름} Gaggenau 200 Series에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau 200 Series 2 페이지. Extractor hood
Gaggenau 200 Series에 대해서도 마찬가지입니다: 사용자 설명서 및 설치 지침 (20 페이지), 빠른 참조 매뉴얼 (2 페이지), 빠른 참조 매뉴얼 (2 페이지)
페이지 인쇄
en
Before using for the first time, read the instruction manual and the safety information it contains.
Setting up Home Connect
Tip: Connect your appliance to a mobile device. You can con-
veniently change all settings using the Home Connect app.
Install the Home Connect app on your mo-
1.
bile device and follow the instructions.
Scan the QR code with the Home Connect
2.
app.
How to use your appliance
Load the tableware.
1.
Only clean tableware that is suitable for dish-
washers. Remove large remnants of food from
the tableware. Check that the spray arms can ro-
Overview of water hardness settings
You can find an overview of the
water hardness values that can
be selected here.
A table of country-specific units
can be found in the instruction
manual.
Hardness
mmol/l
Setting
range
value
Soft
0 - 1.1
0 - 8
Soft
1.2 - 1.4
9 - 10
Adding special salt
To avoid damage to the appliance, only add special
salt to the dispenser for special salt just before the
programme starts.
Unscrew the lid of the dispenser for special salt
1.
and remove.
On initial start-up: Fill the dispenser right up with
2.
water.
Adding rinse aid
Press the catch on the lid
1.
of the dispenser for rinse
aid
and lift
.
Adding detergent
Add the detergent to the
1.
dry detergent dispenser.
tate freely.
Add detergent.
2.
Switch on the appliance
.
3.
Setting the water softening sys-
tem
Medium
1.5 - 1.8
11 - 12
Press
Medium
1.9 - 2.1
13 - 15
1.
To open the basic settings, press
Medium
2.2 - 2.9
16 - 20
2.
for approx. 3 seconds.
Hard
3.0 - 3.7
21 - 26
Press
3.
Hard
3.8 - 5.4
27 - 38
shows "Water hardness".
Hard
5.5 - 8.9
39 - 62
Press
4.
right water hardness has been set.
To save the settings, press
5.
prox. 3 seconds.
Add the special salt to the
3.
dispenser. The water in the
dispenser is displaced and
forced out. Never add de-
tergent.
Place the lid back on the dispenser and turn to
4.
close.
Add rinse aid up to the
2.
max mark.
2
1
Close the lid of the dispenser for rinse aid.
3.
The lid clicks into position.
a
Close the lid of the deter-
2.
50 ml
gent dispenser.
25 ml
15 ml
a
The lid clicks into position.
Select the programme.
4.
Start the programme
.
5.
Remove the tableware at the end of the pro-
6.
gramme.
Programmes
The programme data has been meas-
ured in the laboratory according to
.
European standard EN 60436.
The consumption figures depend on
the programme and additional func-
repeatedly until the display
tion selected.
The runtime will change if the rinse
or
repeatedly until the
aid system is switched off or rinse aid
needs to be added.
for ap-
Programme
Auto 35-45°C
Auto 45-65°
Auto 65-75°
Eco 50°
Quick Wash 45°C
Machine Care
Personalisation function
1
half standard load
max
To cancel the programme, press
7.
approx. 4 seconds.
The programme is cancelled and ends after ap-
prox. 1 minute.
1) Duration [h:min]
2) Energy [kWh]
3) Water [l]
1) 1:40 - 1:55
2) 0,780 - 0,850
3) 11,0 - 13,6
1) 1:40 - 2:40
2) 0,680 - 1,300
3) 7,0 - 15,5
1) 2:10 - 2:30
2) 1,050 - 1,300
3) 9,5 - 13,5
1) 4:55
2) 0,626
3) 9,5
1
1) 0:35
2) 0,710
3) 10,5
1) 2:10
2) 1,350
3) 15,0
1) 0:15 - 0:15
2) 0,050 - 0,050
3) 4,0 - 4,0
for