Gaggenau AF210192 사용자 설명서 및 설치 지침 - 페이지 6

{카테고리_이름} Gaggenau AF210192에 대한 사용자 설명서 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AF210192 16 페이지.
Gaggenau AF210192에 대해서도 마찬가지입니다: 사용자 설명서 및 조립 지침 (16 페이지)

Gaggenau AF210192 사용자 설명서 및 설치 지침
en Familiarising yourself with your appliance
5  Familiarising yourself with your appliance
5.1 Controls
The controls are used to configure all functions of your appliance and to obtain information about the operating
status.
Switching the appliance on or off
​ ⁠
Switches on fan setting 1.
​ ⁠
Switches fan setting 2 on.
​ ⁠
Switches on fan setting 3.
6  Basic operation
6.1 Switching on the appliance
Lightly touch the centre of the filter pull-out.
a The filter pull-out extends.
a The appliance starts at fan setting 2.
6.2 Switching off the appliance
Press
​ ⁠ .
1.
Slide in the filter pull-out.
2.
6.3 Selecting a fan setting
 Press  ​ ⁠ ,   ​ ⁠   or  ​ ⁠ .
6.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
Press
​ ⁠ .
a After approx. six minutes, the appliance automatic-
ally switches to a lower fan setting.
6.5 Switching off intensive mode
 Press  ​ ⁠ ,   ​ ⁠   or  ​ ⁠ .
a Intensive mode is ended early.
6.6 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
Slide in the filter pull-out.
a The appliance switches off automatically after ap-
prox. 10 minutes.
6
Switching on intensive mode
Switching automatic mode on or off
Reset the filter saturation indicator
Switching the lighting on or off/
Setting the brightness
6.7 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press ​ ⁠ .
6.8 Switching off automatic mode
Press ​ ⁠ or
​ ⁠ .
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
6.9 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Press
​ ⁠ .
6.10 Setting the brightness
Press and hold
​ ⁠ until the required brightness is
reached.
6.11 Switching on the audible signal
Requirement: The appliance is switched off.
Press and hold
​ ⁠ and
prox. three seconds until a signal sounds.
6.12 Switching off the audible signal
Requirement: The appliance is switched off.
Press and hold
​ ⁠ and
prox. three seconds until a signal sounds.
​ ⁠ at the same time for ap-
​ ⁠ at the same time for ap-