Gaggenau AH 360-720 작동 및 조립 지침 매뉴얼 - 페이지 5
{카테고리_이름} Gaggenau AH 360-720에 대한 작동 및 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AH 360-720 19 페이지.
Gaggenau AH 360-720에 대해서도 마찬가지입니다: 작동 및 조립 지침 매뉴얼 (19 페이지)
페이지 인쇄
1. Important notes
1.1 For your safety
Damaged appliances must not be operated.
Connecting cables must not come into contact with
hot cooking surfaces.
Do not operate the extractor hood without inserted
lamps. Never operate the appliance without a
grease filter.
Hazardous or explosive substances and vapours
must not be extracted!
The user is responsible for expert use and the
perfect condition of the appliance.
Only ever operate the appliance under supervision.
Fire risk!
Do not flambé meals under the extractor hood!
Only ever deep-fry under the extractor hood under
constant supervision.
Operation of the extractor hood above a hearth for
solid fuels (coal or wood etc.) is only partly
permitted.
Gas appliances may only be used under the
extractor hood when pots and pans are placed on
them!
When using more than 2 gas-operated rings at
the same time, please operate the extractor
hood at level 2 or higher. This prevents a
build-up of heat in the appliance.
Do not place any heavy objects on the appliance;
this will have a detrimental effect on functioning.
Do not clean the appliance with a steam cleaning
apparatus or with water pressure because this
poses a risk of short-circuits.
4
Isolate the appliance from the mains during every
maintenance operation. To do this, remove the
mains plug or actuate the corresponding fuse.
If the mains plug is not accessible, the appliance
must be disconnected by means of the domestic
installation fuse.
Repairs must be carried out by authorised
specialists, thus ensuring electrical safety.
No warranty claims can be lodged in the event of
damage caused by failure to observe these
instructions.
Adequate incoming air must be ensured if a wood,
coal, gas or oil heater or an open hearth is operated
in the same room as the one in which the hood is
installed.
Safe operation is possible whenever the partial
vacuum in the place where the firing equipment is
installed does not exceed 4 Pa (0.04 mbar). This
can be achieved whenever the air needed for
combustion is able to enter through openings that
cannot be sealed, for example in doors, windows,
incoming/exhaust air wall boxes or other technical
means.
Technical modifications reserved.