Gaggenau AH 592-120 원본 작동 및 조립 설명서 - 페이지 13

{카테고리_이름} Gaggenau AH 592-120에 대한 원본 작동 및 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AH 592-120 18 페이지. Freely suspended insular hood
Gaggenau AH 592-120에 대해서도 마찬가지입니다: 작동 및 조립 지침 매뉴얼 (18 페이지)

페이지 인쇄

6. Assembly instructions

6.1 Technical data

Weight without support frame and LK:

AH 590: 35 kg

AH 592: 33 kg

Weight with support frame and LK:

max. 60 kg

Dimensions: 1198 x 700 mm

Electrical connection

Pay attention to the rating plate data.

The mains connecting cable must at least

correspond to the type H 05 VV-F G 0,75.

The appliance must only be connected by an

authorised specialist. The specialist is respon-

sible for perfect functioning of the appliance at its

installation location. He must explain the operating

principle of the appliance to the user with reference

to the operating instructions. He must explain to the

user how the appliance can be disconnected from

the mains whenever required.

Connection possibilities

The plug of the connecting cable is inserted into

the socket on the ceiling. If this is not possible, the

disconnection of all the poles of the appliance from

the mains must be achieved by way of the domestic

fuse, or by using an accessible disconnecting device

with a contact gap of at least 3 mm.

6.2 Installation

The applicable regulations of the energy supply

companies and the regional construction regula-

tions must be observed when installing the hood.

The minimum distance from the worktop to the

bottom edge of the hood is for electrical appliances

600 mm and for gas appliances 700 mm.

The extractor hood was conceived for the exhaust

air mode. The exhaust air can be routed into a se-

parate exhaust air shaft or directly into the open

through the outside wall.

It is not allowed to pass the exhaust air into a flue

or exhaust air chimney that is in operation or into a

shaft that is linked to the heating basement. Consult

the chimney sweep responsible for your district

whenever you wish to pass the exhaust air into a

chimney that is not in operation.

During the course of planning, a chimney sweep

must be consulted if a room air-dependent hearth

is operated in the same room as the one in which a

hood is operated in the exhaust air mode. Adequate

incoming air must be ensured. The applicable con-

struction and safety regulations must be observed.

Adequate incoming air must be ensured if a wood,

coal, gas or oil heater or an open hearth is operated

in the same room as the one in which the hood is in-

stalled.

Safe operation is possible whenever the partial va-

cuum in the place where the firing equipment

is installed does not exceed 4 Pa (0.04 mbar).

This can be achieved whenever the air needed for

combustion is able to enter through openings that

cannot be sealed, for example in doors, windows,

incoming/exhaust air wall boxes or by other techni-

cal means.