Gaggenau AH360120 작동 및 조립 설명서 - 페이지 15

{카테고리_이름} Gaggenau AH360120에 대한 작동 및 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AH360120 17 페이지.
Gaggenau AH360120에 대해서도 마찬가지입니다: 작동 및 조립 지침 매뉴얼 (17 페이지)

페이지 인쇄

76,5

518,5

120

960

min. 650 electric

mind. 650 Elektro

min. 750 gas

mind. 750 Gas

Fig. 16

Fig. 17

All manuals and user guides at all-guides.com

300

310

230

270

Proceed as follows:

Important: Before marking the securing holes,

make sure that no electricity or water lines or

other lines are laid at the drilling points in the wall.

Important: There are two handles on top of the

hood. Only carry the hood using these handles. Do

not lift the hood by the stainless steel side panels

or the aluminium front panel.

– From the bottom edge of the hood, mark a center

line on the wall.

– With the aid of the drilling template, mark the

positions of the screws on the wall. Mark the

contour of the hook-in area. This will make it

easier to hook in the hood (Fig. 16).

– Pay attention to the minimum clearance of 650 mm

for electric cookers and 750 mm for gas cookers.

The bottom edge of the template corresponds to

the bottom from edge of the hood.

– Using the drilling template, drill the 6 holes for

the hood (area I of the drilling template) and the

two holes for suspending the chimney (area II of

the drilling template). In the top two securing

holes for the hood, fix the two hooks d with the

countersunk screws c. Fit the included dowels a

in the other drill holes.

Note: Pay attention to any special accessories that

you may have to fit.

– Screw on the retaining bracket for the chimney

paneling.

– Detach the grease filters.

– Hang the hood on the two hooks. Adjust the

suspended element with the recessed head

screw and align the hood using a spirit level

(Fig. 17).