Gaggenau AI201100 작동 및 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} Gaggenau AI201100에 대한 작동 및 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AI201100 19 페이지.

페이지 인쇄

1. Important notes

1.1

For your safety

–

Damaged appliances must not be operated.

– The appliance must only be connected by an

authorised specialist, paying attention to

the relevant regulations of the power supply

companies and the regional construction

regulations.

Also observe the assembly instructions!

–

Connecting cables must not come into contact

with hot cooking surfaces.

– Do not operate the extractor hood without

inserted lamps.

– Never operate the appliance without a grease

filter.

– Hazardous or explosive substances and vapours

must not be extracted!

– The user is responsible for expert use and the

perfect condition of the appliance.

– Only ever operate the appliance under super-

vision.

–

Caution!

Over-greased filters are a fire risk!

Only ever deep-fry under the extractor under

constant supervision. Be sure to clean the

grease filter on a regular basis and change the

activated charcoal filter.

Fire risk! Do not flambé meals under the

–

extractor hood!

– Operation of the extractor hood above a hearth

for solid fuels, which poses a fire risk (e.g. sparks)

is only permitted, if the hearth possesses a

closed and fixed lid. The current local

regulations must be obeyed. This does not apply

to gas hobs and gas cookers.

– Hobs may only be used under the extractor hood

when pots and pans are placed on them!

– When using more than 3 gas-operated rings at

the same time, please operate the extractor

hood at level 2 or higher. This prevents a build-

up of heat in the appliance.

– For safety reasons, do not place any heavy

objects on the top of the appliance.

– Do not clean the appliance with a steam

cleaning apparatus or with water pressure

because this poses a

– Isolate the appliance from the mains during

every maintenance operation. To do this, remove

the mains plug or actuate the corresponding

fuse.

If the mains plug is not accessible, the appliance

must be switched off at fuse point.

– Repairs must be carried out by authorised

specialists, thus ensuring electrical safety.

– No warranty claims can be lodged in the event

of damage caused by failure to observe these

instructions.

– Adequate incoming air must be ensured if a

wood, coal, gas or oil heater or an open hearth is

operated in the same room as the one in which

the hood is installed.

– Safe operation is possible whenever the partial

vacuum in the place where the firing equipment

is installed does not exceed 4 Pa (0.04 mbar).

This can be achieved whenever the air needed

for combustion is able to enter through openings

that cannot be sealed, for example in doors,

windows, incoming/exhaust air wall boxes or

other technical means.

– If the appliance is to be operated only with the

window open (to ensure adequate incoming air),

you can use the

window switch.

A switch (normally open) is fitted on the window.

On the appliance, this switch is connected to the

window switch terminal on the main electronics.

The appliance can now only be operated when

the window is open.

Important: the window switch must only be

connected by an authorised specialist.

Note: the light function works without restriction.

– After a power failure, the extractor will not go on

again automatically. You can recommence

operation by turning a knob or by pressing any

key.

Technical modifications reserved.

risk of short-circuits.