HI-Q TOOLS 60150700060 사용 설명서 - 페이지 4
{카테고리_이름} HI-Q TOOLS 60150700060에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HI-Q TOOLS 60150700060 10 페이지. Fork work stand (front) for motorcycles
페이지 인쇄HI-Q TOOLS FORK WORK STAND (FRONT)
60150700060
Ord Nr.
CONTENT
1 fork work stand front
2 castors incl. fi xing material
The HI-Q TOOLS fork work stand (front) simplifi es a lot of reparation and mounting
work on your two-wheeler. Modern motorcycles often have a high empty weight of
several hundred kilogramms. Therefore please use the HI-Q TOOLS fork work stand
(front) always with the greatest care in accordance to these operating instructions
and the manufacturer's specifications to avoid damage on your two-wheeler and
injuries on involved persons.
The HI-Q TOOLS fork work stand (front) is to use always together with a rear work
stand. Make sure you lift the rear of the motorcycle fi rst. Never use the stand for
other purposes.
ASSEMBLY
The self-locking nuts of the security screws have to be tightenend gently without tigh-
tening the profi le of the stand. The stand is ready as soon as the tiller is compared to
the fork supports and the right size is chosen (for middle to middle holes in fork legs
width approx. 18-23 cm).
USE
Before using the HI-Q TOOLS fork work stand (front) check if your motorcycle generally
fulfi ls the conditions to be lifted by the HI-Q TOOLS fork work stand (front). Not for
models where the lower ends of the fork right and left are on very different heights.
The max. load capacity is 150 kg – therefore the total weight of the two-wheeler incl
accessories may not exceed 300 kg. If the front wheel shall be demounted, the axle has
to be loosened before jacking up the motorcycle. The same is valid for other tightened