Gaggenau AT 400-730 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} Gaggenau AT 400-730에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AT 400-730 16 페이지. Backsplash ventilation
Gaggenau AT 400-730에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (16 페이지)
페이지 인쇄
operating the deep fryer VF 411 in front of the
backsplash ventilation.
Ovens that do not exceed the maximum allowed
cabinet temperature can be combined with the
backsplash ventilation if built-in situation permits.
Do not use the fan housing as a support base. An
intermediate shelf in the base cupboard must be
removable.
Accessories for Installation
You can order the following accessories for
installation:
AA 409-400 : Furniture support 33
AT 400-700
AA 409-430: Furniture support 45
for AT 400-730
Recommended as bearer for the countertop,
instead of a cabinet frame, or to support the fan
housing, replacing the need for a cabinet base.
AA 409-900 : Telescopic extension for AT 400-700
AA 409-930: Telescopic extension for AT 400-730
Telescopic extension max. 4
between backsplash ventilation and fan housing.
AA 010-410 : Air exhaust grille for AT 400-700/730.
Stainless steel color, 36 ˝ (90 cm). Including
installation fittings. Height adjustable.
ZB 020-090 : Additional louvre for air exhaust grille
AA 010-410. Height 1
louvres can be installed.
Dimensions – Figure 1
A
The backsplash ventilation cover must remain
removable to permit access to the fluorescent
tube.
B
Access to the base cabinet from the front
must remain possible to change the odor
filter.
Combination Possibilities – Figure 2
Installations A, B, and C are possible against a wall
or in an island.
A
Combination with standard depth cooktop
Work surface depth 29
combination with Gaggenau Vario 400 or
cooktop. Cabinet depth 21
pull-out drawers.
B
Installation between two cabinets with
continuous work surface
Work surface depth 29
combination with cooktop. Open storage
shelves under cooktop. Base and rear wall
must remain detachable. Support fan housing
with furniture support AA 409-400/430.
8
7
/
˝ (86 cm) for
8
11
/
˝ (116 cm)
16
5
/
˝ (110 mm)
16
3
/
˝ (30 mm), several
16
1
/
˝ (75 cm),
2
5
/
˝ (55 cm),
8
1
/
˝ (75 cm),
2
C
Combination with built-in oven 17
18
7
/
˝ (45 or 48 cm) high
8
Work surface depth 29
combination with cooktop and Gaggenau
oven EB 388 or compact oven (must not
exceed the maximum allowed cabinet
temperature). Cabinet depth 21
Use telescopic extension AA 409-900/930
between upper part of backsplash ventilation
and fan housing.
D
Combination with built-in oven 23
(59 cm) high
Island oversize depth, combination with
cooktop and oven (must not exceed the
maximum allowed cabinet temperature).
2x cabinet depth 21
pull-out drawers. Telescopic extension
AA 409-900/930 can be used.
E
Combination with Vario 400 and built-in
7
oven 18
/
˝ (48 cm) high
8
Island oversize depth, combination with
Gaggenau Vario 400 (only VC, VG, VI, VP,
VR) and oven EB 388. 2x cabinet depth
21
5
/
˝ (55 cm), short pull-out drawers.
8
Telescopic extension AA 409-900/930 can be
used.
Dimensions – Figure 3
If necessary, reposition the lower hinges on swing
doors.
The opening in the lower cabinet shelf may be
increased as long as the free minimum cross-
section of 1.9 sq.ft. / 1800 cm
The final position of the base cabinet must be taken
into account when measuring the cutout in the base
cabinet. All depths are measured from the rear
edge of the upper part of the backsplash
ventilation.
The exhaust outlet in the cabinet toekick should be
as large as possible (min. 112 sq.in. / 720 cm
minimize draughts. The location of the exhaust
outlet in the cabinet toekick is customer-defined.
The air exhaust grille AA 010-410 can be used to
cover the exhaust outlet in the cabinet toekick.
For island solutions: alternatively rotate fan 180°.
The remaining surface of the countertop
(min. 1
15
/
˝ / 50 mm) between the recesses
16
must be reinforced with a support. Furniture
supports AA 409-400/430 can be used for this
and to stabilize the cabinet.
Cabinet Dimensions Wall Situation –
Figure 4
All depths are measured from the rear edge of the
upper part of the backsplash ventilation. Make
allowance for a possible fitted rear panel.
3
/
˝ or
4
1
/
˝ (75 cm),
2
5
/
˝ (55 cm).
8
1
/
˝
4
5
/
˝ (55 cm), short
8
2
is maintained.
2
) to