Gaggenau AW270192 사용자 설명서 - 페이지 18

{카테고리_이름} Gaggenau AW270192에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau AW270192 20 페이지.

en Installation instructions

Variant A: Flat extractor hood with flue cover

Variant B: Sloped extractor hood with flue cover

Variant A: Flat extractor hood without flue cover

Variant B: Sloped extractor hood without flue cover

Installing the appliance bracket

Screw on the appliance bracket for the extractor

hood hand-tight.

Use a spirit level to align the appliance bracket hori-

zontally and screw it firmly in place.

Installing the appliance

Remove the protective film from the rear.

Once the appliance is installed, fully remove the

‒

protective film.

Hook the appliance into the appliance bracket in

such a way that it clicks firmly into place.

To align the appliance, slide the appliance to the

right or to the left as required.

Tighten the safety screws.

When you install a flue cover, install the bracket and

hold it in place while screwing it in tight.

Piping

Air extraction mode

¡ If you operate the appliance in air extraction mode,

a flue cover must be installed.

Circulating-air mode

¡ If you operate the appliance in circulating-air mode,

the enclosed odour filters must be installed.

¡ For operation in circulating-air mode, the installation

of the flue cover is optional.

Note: If you are using an aluminium pipe, smooth the

connection area beforehand.

We recommend the piping with an exhaust air pipe dia-

meter of 150 mm.

Establishing the exhaust air connection (exhaust

pipe, 150 mm diameter)

Secure the exhaust pipe to the air pipe connector.

Establish the connection to the exhaust air opening.

Seal the joints.

Establishing the exhaust air connection (exhaust

pipe, 120 mm diameter)

Secure the reducing connector to the air-pipe con-

nector.